Welcome to the Land Rover Forums - Land Rover Enthusiast Forum.
If this is your first visit, be sure to check out the FAQ by clicking the link above.
You may have to register before you can post: click the register link above to proceed.
To start viewing messages, select the forum that you want to visit from the selection below.
I added both jumpseats to my '03. I wont waste the time with a full write up of the procedure, sufficed to say all mounting points for the seats ARE in place.
__________________
2003 Disco II SE 85K miles
Mods:
- HID Fog lights
- EBC Green slotted rotors & pads
I had to modify the belts. I am going to have 2 kids riding back there in 5 point harness car seats which do not take shoulder harnesses. So what i did was get a length of seat belt and sew it on my surger sewing machine after it was looped through the original shoulder buckle. The using the older seatbelts mounting point I attached it to the wall bolts.
I am only keeping them in for about 3 weeks then they are coming out so I did not replace all of the plastic panels, just used a dremmel and a cutting wheel to cut out the H shaped holes in the plastic. Once I take the seats out I can put the original plastic buckets back in and you cannot see any seats were even in the truck.
__________________
2003 Disco II SE 85K miles
Mods:
- HID Fog lights
- EBC Green slotted rotors & pads
we are kind here. unlike other forums. im sure everyone would be curious to see the custom work you did. good or bad we can learn and comment and maybe help or learn and improve from your work.
__________________ -Ed
99 DII, TF +2" HD & steering damper, TreadWright 265/75/16, ARB front, BritPart rear, Warn m8000 with synth, Columbia Overland gate panel & dual battery tray, Safari snorkel, RoverBones diff guards, RockWare sliders, DieHard Plat Deep Cycle, Chalkboard Headliner, CB, Wilderness Rack, 6 hella 700 ff's w 100w bulbs, 2 hella work lights
93 RRC TF track rod, tie rod & steering damper, TRW rims
Adding jumpseats to an 03 Disco II
