Welcome to the Land Rover Forums - Land Rover Enthusiast Forum.
If this is your first visit, be sure to check out the FAQ by clicking the link above.
You may have to register before you can post: click the register link above to proceed.
To start viewing messages, select the forum that you want to visit from the selection below.
I saw some front seats from a 2002 discovery and I wondered if anybody ever tried to put them in a Discovery 1. Will the bolt holes match up? Will the electrical plugs match up? If not is it possible to seperate the seats from the base and swap the tops only? These are really nice seats. Need some advice befor I spend the $100.00.
new water pump, fan clutch, thermostat, lower radiator hose, powersteering hoses(3), alternator and driveshaft rubber coupling.
1990 Toyota 4 Runner SR5 230k(fell on its side, left her my friend said it was still on when we took off, I was drunk. Came back, all fluids gone. Topped her off and she started right up.)
Need Parts? paulgrant@mac.com, or 203-770-1699 willtillery@roverguy.com, or 434-251-9331
Paul PTSchram 260-804-0458
PM Marty(Drillbit)[url]http://www.landroversonly.com/forums...o=newpm&u=5940
British Parts of Utah, http://www.bputah.com/
Lucky8, http://lucky8llc.com/
I bought D2. I tried, I returned for credit at my salvage yard, and I found that a D1 passenger seat would fit in the driver spot just fine, so I got two passengers ($27 each). See Disco 1 driver seat swap
D2 to D1 seat swap possible?
