Driver's door hard to open from outside
#21
#22
Charisma wrote
Hi there,
it's the key is broken..a half of it am not sure if it's still inside..and i called the land rover service centre and not sure the cost maybe around $300 or so..
and, i dont have money to pay so am trying to do it by myself.
thank you.
#24
I can't get in.
And, even those people from AMA(Roadside Assistant), can't do anything and now i have no choice and send it to the LAND ROVER SHOP, and just to get a key and get in...
cost me: $700..and now am planning to sell it, coz i dont have money to get it when it done by nextweek.
Thank you for all your advise.
And, even those people from AMA(Roadside Assistant), can't do anything and now i have no choice and send it to the LAND ROVER SHOP, and just to get a key and get in...
cost me: $700..and now am planning to sell it, coz i dont have money to get it when it done by nextweek.
Thank you for all your advise.
#25
Door handle fix
There is a linkage that connects at the outer door handle. Straight piece of linkage that comes up vertically and connects to the handle. The lower part connects to the mechanism/actuator has a small white fitting that is threaded.
Detach the linkage at the handle and turn this linkage clockwise/tightening to take up the slack, a few revolutions at a time. Re attach and test again. Keep going until it opens as it should.
Detach the linkage at the handle and turn this linkage clockwise/tightening to take up the slack, a few revolutions at a time. Re attach and test again. Keep going until it opens as it should.
I didn’t want to buy a new piece so I epoxied a zip tie to the top of the threads to act as a stop. Once that dried, I added epoxy to the threads of the rod and inserted it in the plastic piece. Door opens without issue now!!!
#26
Thread
Thread Starter
Forum
Replies
Last Post
Prowler9876
Discovery II
3
02-22-2010 08:31 AM
marlymarl
General Tech Help
2
07-28-2005 12:23 AM