03 free-new headgaskets, belts, etc., now won't start

[kyndrad77]

Hi, I blew my head gasket a few weeks ago and today got it put back together. Nothing is missing, everything's there, and the starter is trying but the engine won't start. Anciliary belt is turning, but not even a sputter. Has gas, oil, coolant, etc., I just don't know. Would this be because I drained the oil and the block was without oil for a long time (dry crank?) Any help or ideas would be great. Thanks.

[kyndrad77]

I went over everything, tested spark and CPS, no problems there. Thinking I must've missed something with the timing. I know my torques and other stuff were correct. Truck ran even after head gasket went, so this has to be something I did with timing? If it is, does anyone have any tips for adjusting the crankshaft to the camshaft if that is at all skewed? Thanks. :-)

[kyndrad77]

The cylinder liners had a small bit of rust accumulated from the coolant invasion. I cleaned them up as best I could and I don't think there was enough to do anything? Anyone have any comments about that? Thanks.

[uiasdsdsfasds]

I went over everything, tested spark and CPS, no problems there. Thinking I must've missed something ottawa asian escort with the timing. I know my torques and other stuff were correct. Truck ran ottawa asian escorts even after head gasket went, so this ottawa escort has to be something I ottawa escorts did with timing? If it is, does anyone have any tips for adjusting the crankshaft to the camshaft if that is at all skewed? Thanks. :-)