key open car in the door but not with the remote?
#1
#2
I used the below procedure to get my no functioning remote to work. I had to do it twice because I did not time it right.
I have not tried it yet (I will in about a week), but I understand that it is also the same procedure to program a New remote.
Close the car.* Insert the key in the drivers side lock pressing and holding the remote button with the lock symbol.* Turn the key to the right as if locking, still holding the lock button down.* Hold in this position for 3 seconds. Turn back to the centre position and pull the key out - STILL HOLDING THE KEY BUTTON.* Once the key is out release the lock button.
I have not tried it yet (I will in about a week), but I understand that it is also the same procedure to program a New remote.
Close the car.* Insert the key in the drivers side lock pressing and holding the remote button with the lock symbol.* Turn the key to the right as if locking, still holding the lock button down.* Hold in this position for 3 seconds. Turn back to the centre position and pull the key out - STILL HOLDING THE KEY BUTTON.* Once the key is out release the lock button.
#3
Thread
Thread Starter
Forum
Replies
Last Post
bcolins
Discovery II
1
12-08-2013 09:17 PM
bcolins
Discovery II
3
11-08-2011 06:15 PM
RROJ
General Range Rover Discussion - Archived
2
10-09-2010 07:39 AM
RROJ
General Range Rover Discussion - Archived
0
10-08-2010 09:56 PM
marlymarl
General Tech Help
2
07-28-2005 12:23 AM