D1 Motor Swap to Chevy 327 0r 350

[DuplinDisco]

I'm probably going to get slammed for this but I'm seriously considering swapping out the factory 3.9L with a Chevrolet motor (GM made a few Rover motors correct?)....only because I already have them and most of the parts. I've got a 327, 350, and a 400...along with a variety of trannys. I found this video on one with suppossedly a 350 but with no info:
http://videos.streetfire.net/video/C...-Wi_154557.htm

Does anyone know of any D1's that have tried this? Looking to see what is all involved. Thanks!

[LRDISCO]

I have thought of that a few times as well. I saw a range rover classic with a 350 on ebay awhile back. I'd go for it, sounds like a good idea to me.

[deadpass]

As long a the transfer case and axles can handle the extra power and torque I'd say go for it. Take plenty of pictures too.

[Willie 00D2]

Here is a link to some information.

http://www.rangerovers.net/rrupgrades/index.htm#swapgm

Willie

[Landzu]

Sounds like a whole drive train swap.

[Spike555]

I think you would be better off dropping in a diesel. From what I understand it is a very easy swap, especially is you use a Rover diesel.

[DuplinDisco]

ORIGINAL: Willie 00D2

Here is a link to some information.

http://www.rangerovers.net/rrupgrades/index.htm#swapgm

Willie

Good info..thanks!

If I do this..it will be a bit down the road. I know the Disco's motor will need to be replaced eventually...I would like to be ready with a swap when it does.

[Spike555]

Why not just have it rebuilt when it goes? It would be easier, probally cheaper and you could have it milled, bored and re-sleeved.

[geotrash]

http://www.mdengineering.co.uk/index.php?act=about

[Spike555]

http://www.obwcanada.com/
http://www.bellintercoolers.com
http://www.mdengineering.co.uk/
Everything you need to do a diesel conversion. I know a guy in TX who did this with great success.