Going to take off the front diff this week
#22
#25
#27
I already have, and I have/am tried/trying to read the section involving the disassembly. But the thing is I get confused about what it is talking about. Since I can't visually see the part(s) in front of me and feel it, I have no idea what the drive flange or the slip pin is, and it talks about not installing the oil seal because of pre-load and things like that..
1. So what I was thinking of asking what I need
2. Having everything (53mm/2 2/16" socket, new lock nuts, wheel bearings, grease, lock washers, diff, oil seals and gaskets, etc)
3. Taking it apart using the RAVE so I could actually see what it was talking about, and knowing I did the job right because I used all my parts.
1. So what I was thinking of asking what I need
2. Having everything (53mm/2 2/16" socket, new lock nuts, wheel bearings, grease, lock washers, diff, oil seals and gaskets, etc)
3. Taking it apart using the RAVE so I could actually see what it was talking about, and knowing I did the job right because I used all my parts.
Last edited by calebbo; 02-07-2011 at 02:40 PM.
#29
Join Date: Mar 2010
Location: Pittsburgh PA suburbs.
Posts: 5,584
Likes: 0
Received 7 Likes
on
7 Posts
Have you tried printing out all the relevant sections. I find that is easier than going from screen to screen. You can use it a printed guide while you are
doing something, mark it up with wrench sizes, check it off as you go and so forth.
That is what I have done on several of the involved tasks. Try it, you may like it.
doing something, mark it up with wrench sizes, check it off as you go and so forth.
That is what I have done on several of the involved tasks. Try it, you may like it.