My front license plate and mounting bracket were stolen, what do I need 2 mount plate
 

My 2003 D2 front license plate and what ever plate or bracket it was attached to was stolen off my truck. Got new plates today,....dont know what I need to mount the plate on the front. Can someone post a pic or maybe an exploded view / diagram, or,.....post a link??

Thanks, Brian

something like this:
Front License Plate Mounting Bracket Black Frame 4 Screw Caps for Land Rover | eBay

Thanks for posting the pic and link. I am also missing what is BEHIND the plate mount. I have two one inch diameter holes about 8.5 inches apart on the face of my bumper. They go all the way through the bumper.

Wondering if someone can post an exploded diagram or a picture so I can see what should be in those holes??

Pic of my bumper (what is left of it) below.

BC

Exploded view / diagram of front license plate bracket/mount
 

Anyone have an exploded view of the front license plate mount/bracket?

BC

i looked at breakdown and only say this part:
License Plate Bracket Front (Genuine Part # DRE500080PMA ) - Land Rover body panels/fittings/trim exterior from Atlantic British

Thanks, Ill have to take a closer look at it tomorrow. May swing by the dealer and see if they have one I can look at.

Joemamma, just noticing you have a 2003 also. Any chance you could undo your front license backing plate and see what is in those two holes?? Maybe snap a pic of it?

BC

On the 03/04 there is a single brass threaded sleeve in the center of the bumper support. The bumper cover has a hole in it to allow access of the bolt to pass through.

The actual license plate holder attaches in the center with a torx head screw to the above mentioned location (T30 maybe), then has 2 Phillips head screws on the bottom.

thanks for the input,....I figured the cylindrical center depression must have something to do with mounting the plate bracket. Thanks for the input. Went to a wrecking yard today to check out a D2 they had there,....but it was an early D2 and the entire bumper assembly was gone.