What did you do with your DII today?
#5902
#5903
The following 2 users liked this post by mbrown3039:
No Doubt (09-19-2018),
The Deputy (09-19-2018)
#5904
#5905
I recently got a pretty serious vibration and squeaking on acceleration in my '02 Disco 2. Thanks to this site, I was able to diagnose it as the front drive shaft. Apparently the u-joints go bad from heat from the exhaust and water runoff from the a/c. I replaced the driveshaft myself, which turned out to be pretty simple and due to the ground clearance I didn't even have to lift it. Now I'm planning to rebuild the stock shaft to have as a back up or sell. If you have any questions about the procedure, feel free to ask.
The following users liked this post:
Busta (09-20-2018)
#5906
Replaced the really bad Watts link with a good used one tonight. I may replace with panhard later but this will do.
Next up is rust repair patch in rear frame in pass side at hoop. Then clean framer and seal with chassis saver.
Picking up a Oslo Blue hood and fender Saturday to replace my clear coat damage. Can't wait!
#5907
#5910