I'm in Raleigh, NC - $27,000 OBO- Rover is in excellent condition, has been babied/garage kept.

4.6 HSE Callaway Edition: The top of the line model in 1999 was a limited edition (220 were made and had stickers on the dash that say Callaway and have the number, this is #77) 4.6 HSE modified by Callaway in Old Lyme, Connecticut. They were available in Niagra Gray (like this one), Epsom Green, or Rutland Red. They had much of the black plastic painted body color and special dual exhaust system. The high performance Callaway engine with 240 bhp at 5,000 rpm and peak torque of 285 lb.-ft at 3,500 rpm improved the 4.6 HSE acceleration 0-60 mph from 9.7 sec to 8.6 sec. The Callaway 4.6 HSE sold for $80,000.



This vehicle has a 100,000 mile warranty with plenty still left! Roof rack can accommodate 2 bicycles, several surfboards, a kayak, etc.



Pirelli Scorpion Zero Tires - 255/55/R18



You have never ridden or driven in a Range Rover with acceleration/pickup like this one! Very limited edition Callaway is a MUST HAVE.





The "short block" of the engine is the same as other Land Rover 4.6 HSE models. Short-blocks used for the 4.6L Callaway engines were stamped with a 9.60:1 compression ratio marking from Land Rover. The increase of 0.25 points, up from the standard 4.6L compression ratio of 9.35:1 was achieved by a modification to the cylinder heads. The cylinder heads were also modified to improve the airflow into and out of the combustion chambers. The inlet manifold gasket front valley clamp has been changed to accommodate the heater hose positioning on the bottom front of the Callaway manifold. The ram pipe housing has been modified by shortening the ram pipe tube lengths. The intake runner lengths were tuned to increase both power and torque. The black plastic air inlet tube was replaced with a larger diameter fancy looking carbon fiber inlet tube to match the larger throttle bore in the plenum. The air cleaner box base was modified to increase the airflow. The Lucas GEMS ECU was calibrated to support the mechanical changes to the Callaway engine (the Callaway engine had the same basic FI as in 1998 and did not have the Bosch system that was on other 1999 HSEs).

<><>The Callaway drivetrain was also modified. The automatic transmission used in the Callaway 4.6 HSE Range has a different torque converter and the transmission control unit (TCU) has been recalibrated to take advantage of the increased torque and power of the engine. The shift points in both "NORMAL" and "SPORT" modes have been changed to match the engine's increased power. <>

The electronic shift transfer case has a new ratio sprocket set and chain. The resulting new ratios provide a high range ratio of 1.294:1, and a low range ratio of 3.481:1. The ratio change improves acceleration performance in high range while also providing improved off-road "crawl" performance and coast down rates in low range.

The front axle shafts used on the Callaway 4.6 HSE have been strengthened to withstand the increased torque to the front wheels from the engine and transmission changes. A material change in the axles ensures durability will be maintained for the front axle half shafts. <>

Callaway decided to use a four-pin front differential to accommodate the increased torque rather than the two-pin front diff used on standard production Range Rovers. After working with Callaway on the four pin front diff Land Rover decided to put them in all of the 1999 Range Rovers since the 4 wheel traction control that added ABS regulated traction control to the front axle in 1999 also put extra stress on the front diff (Range Rovers from 1993-1998 only had traction control on the rear axle). <>

The Callaway dual exhaust had reduced backpressure and was similar to the dual exhaust that all NAS Range Rovers got in the 2000 model year. Changes to the exhaust system were made rearward of the catalyst "Y" pipe. The exhaust system backpressure was reduced by 43 percent, and the interior sound level in the passenger cabin was virtually unchanged. The center silencer provides reduced backpressure and is constructed from stainless steel. A twin tail pipe system was selected to provide a performance look and sound. The straight exit twin outlets are accented by T-304 stainless steel resonator tips to visually differentiate the Callaway 4.6 HSE from other Range Rovers. The pipes are welded on to the stock mufflers and the rear bumper has cut outs for the tailpipes like it had in 1995 and 1996 (the stock single muffler pointed down and the rear bumper did not have any cut out on the 1997, 1998 and non-Callaway 1999 Range Rovers).<>The exterior of the Callaway 4.6 HSE Range Rover is had painted body color components. The exterior components painted to match the body color are, the Entire Front Bumper cover, the Front Grill, Left and Right Headlamp trim, Left and Right Door Mirror Casings, Rear Bumper including area with Exhaust Tip Openings

All Callaway Range Rovers came with the "Proline" 18 inch 5-spoke alloy wheels.

Body Colors Available: Niagara Gray , Epsom Green, and Rutland Red

The vehicles are badged with "CALLAWAY" on the upper engine plenum, and on the lower rear tailgate under the 4.6 HSE logs (some models also have Callaway stickers on the front fenders.

Inside, the Callaway RRs some had additional wood surrounding the power window switches and HVAC controls wood and leather steering wheels and most (but not all) had GPS (this one does not have GPS).