Land Rover Forums - Land Rover Enthusiast Forum

Land Rover Forums - Land Rover Enthusiast Forum (https://landroverforums.com/forum/)
-   Retired - Private For Sale/Trade Classifieds (https://landroverforums.com/forum/retired-private-sale-trade-classifieds-20/)
-   -   2002 Discovery - lockers, bumpers, and more (https://landroverforums.com/forum/retired-private-sale-trade-classifieds-20/2002-discovery-lockers-bumpers-more-88784/)

fgd 03-24-2018 08:02 PM

2002 Discovery - lockers, bumpers, and more
 
Hi everyone, I'm selling my Disco. I needed to get a truck and could not afford to have both the truck and the Disco. So here we are. All info below. It's in Portland, OR and listed there on CL also.

2002 Land Rover Discovery 2. SD model with no sunroofs (Yay! No leaks!) and with vinyl seats. 112,766 miles. Rebuilt 4.6L engine with about 15,000 on the rebuild. Center Diff Lock. ARB air lockers on the front and rear with ARB compressor. Safari Gard bumpers front and rear, both with extended skid plates. 3 Baja Design lights on the front wired to the fog light switch. Superwinch 8500lb winch. Rock sliders. Full width front diff guard and rear diff guard on the pumpkin. Quick disconnect front sway bar. No rear sway bar. Snorkel. 2 inch OME lift. 255/85/16 BFG KM2 tires with good life left on them. Odyssey red top battery. Backup camera. New Alpine stereo with bluetooth and mic for hands free calls. New Land Rover rubber mats. Moderate exhaust from the cats back. Did great at DEQ and has temporary tags as I moved the plates to my truck. ATV permit good until the end of 2018. Thule rack and dog guard for cargo area and some recovery gear (not pictured).

Work done while I've owned it:
- New SAI solenoid
- Wired reverse light to mini light bar above license plate
- New front drive shaft installed at Ship's Mechanical - a local Land Rover specialty repair shop.
- New driver side rear door lock acutator
- Gear oil change in transfer case and both differentials
- New 180* thermostat
- New brakes all around with DBA slotted rotors and Akebono ceramic pads. Brake lines flushed and bled
- New water pump
- Replaced plastic air intake plenum
- ARB compressor maintenance - New seals and pressure switch
- New idler pulley
- New wire set and plenum gasket, throttle body heater bypass, new hoses to heater intake. All done at Ship's.
- New drag link and terrafirma steering damper

Work done by previous owner all done at Lamorna Garage, a highly reputable Land Rover repair shop in Seattle, with receipts.
- New SAI pump
- XYZ switch
- New motor mounts
- Turn signals moved to reverse light location
- Header joint wiring replaced
- Engine replacement. Rebuilt engine came from Marvelous Motors and installed by Lamorna

Full disclosure of stuff that needs work:
- Saggy headliner. Very common and was on my to-do list, but never got to it.
- Exterior C pillar plastic trim is gone on both sides. Was waiting to replace when doing the headliner.
- Very slow leak on the transfer case. Doesn't mark its territory, but visible when you crawl underneath. These transfer cases have a notoriously hard to seal inspection plate.
- Uses a little oil between oil changes
- Small rock chip in the windshield near the edge on driver's side. I filled with the DIY kit and has not spread, but still visible.
- Paint is in OK shape. There are a few clear coat spots, some forest pin striping, and some parking lot dings.
- A/C compressor has a rattle that is noticeable at idle. A/C functions fine and pulley bearing seems in good shape. Had it to Ship's to diagnose and they recommended a new compressor eventually, but is fine in the mean time.
- Driver seat has a rip in the bolster and the seat heater doesn't work. Passenger seat heat works great though.
- One horn button does not work.

Price is $10,000 OBO. Clean title on hand, in my name. Happy to answer any questions.

https://cimg7.ibsrv.net/gimg/landrov...e1b4f72d1a.jpg https://cimg9.ibsrv.net/gimg/landrov...db3e9a1a65.jpg https://cimg0.ibsrv.net/gimg/landrov...b559e0fdce.jpg https://cimg1.ibsrv.net/gimg/landrov...0db7e9d8f0.jpg https://cimg3.ibsrv.net/gimg/landrov...147688e0a1.jpg https://cimg5.ibsrv.net/gimg/landrov...984a323d9f.jpg https://cimg6.ibsrv.net/gimg/landrov...dd6ff41618.jpg https://cimg7.ibsrv.net/gimg/landrov...f1fe54bfd2.jpg https://cimg8.ibsrv.net/gimg/landrov...2df684aae6.jpg https://cimg9.ibsrv.net/gimg/landrov...30aee9a5b4.jpg https://cimg1.ibsrv.net/gimg/landrov...159a418d73.jpg https://cimg3.ibsrv.net/gimg/landrov...1385dcb473.jpg https://cimg6.ibsrv.net/gimg/landrov...ebd7337450.jpg https://cimg9.ibsrv.net/gimg/landrov...bc18ba7533.jpg https://cimg0.ibsrv.net/gimg/landrov...3b9bc1a4de.jpg https://cimg1.ibsrv.net/gimg/landrov...508d4ddb6a.jpg https://cimg3.ibsrv.net/gimg/landrov...a235cd0ef3.jpg https://cimg5.ibsrv.net/gimg/landrov...2e23e49c06.jpg https://cimg8.ibsrv.net/gimg/landrov...f0b1f2225d.jpg https://cimg0.ibsrv.net/gimg/landrov...52f265ab5f.jpg

fgd 04-20-2018 12:26 AM

bumping this one back to the top.
Happy to provide more photos or answer any questions.

fgd 04-26-2018 01:23 PM

Dropping the price to 9900.

fgd 05-22-2018 07:30 PM

Update:
Price drop to $9600.
Purchased a good used a/c compressor to replace the current unit. Don't know when I'll have time to get it installed though.

Jeff Blake 05-23-2018 12:18 PM

Nice truck. I want lockers....

fgd 05-23-2018 01:15 PM

Thanks Jeff. I'm sad to see it go, but I can't justify having it and a pickup.
The lockers are so nice. They are excellent on trails.


All times are GMT -5. The time now is 08:57 PM.


© 2024 MH Sub I, LLC dba Internet Brands