Land Rover Forums - Land Rover Enthusiast Forum - Search Results

 
Search: Posts Made By: WaltNYC
Showing results 1 to 25 of 28
Search took 0.01 seconds.
Forum: Discovery I
Yesterday, 10:04 PM
Replies: 3
Views: 205
Posted By stillruns

$300-$500 is the range. Any more than that and...

$300-$500 is the range. Any more than that and you will be kicking yourself.
Forum: Discovery II
Yesterday, 08:13 PM
Replies: 22
Views: 1,371
Posted By Dan7

You need an ultra gauge or other real time OBDII...

You need an ultra gauge or other real time OBDII temp reader. At 225F, The stock temperature sensor won’t budge from dead center, so you were somewhere over that.
Forum: Discovery I
06-20-2019, 07:53 AM
Replies: 4
Views: 544
Posted By OverRover

Yes, the longer "wing" goes toward the center. ...

Yes, the longer "wing" goes toward the center.

And the direction will matter because the pad retaining spring needs to index on the top of the pad to provide proper tension/ pad orientation.
...
Forum: Discovery II
05-07-2019, 07:15 PM
Replies: 387
Views: 165,584
Posted By ACEngineer

This will be the last of the beta kits. After...

This will be the last of the beta kits. After this round of testing is through, we plan to release the kits on our website.
Forum: Discovery II
04-16-2019, 03:47 AM
Replies: 387
Views: 165,584
Posted By Daedrix

Some you guys looking to do the swap might get...

Some you guys looking to do the swap might get lucky like me and get a lm7 engine, harness, ecu, accessory drive and all the sensors from a running truck for $900. Then you can either rewire the...
03-27-2019, 04:45 PM
Replies: 15
Views: 1,361
Posted By The Deputy

Was hoping to get the floormats sold...

Was hoping to get the floormats sold quickly...but hasn't happen...yet. But, l'm just adding in the sale amount (for when l do eventually sell them) and sending off the check from the sale of these...
Forum: Discovery I
09-16-2018, 09:23 PM
Replies: 30
Views: 2,548
Posted By Crunkgringo

The problem was the reluctor ring contacting the...

The problem was the reluctor ring contacting the crank postion sensor. No check engine light for a week now. I drove 175 miles this weekend and no problem except an oil leak I have to chase down...
Forum: Discovery I
08-12-2018, 10:27 PM
Replies: 4,258
Views: 784,340
Posted By Llamasayswhat

I took my 96 up to the summit of Mauna Kea...

I took my 96 up to the summit of Mauna Kea saturday night to try and catch some of the perseid meteor shower. I only saw probably 5 or 6, but the Milky Way was out in force and it was as gorgeous as...
Forum: Discovery I
07-12-2018, 08:46 PM
Replies: 4
Views: 541
Posted By Toran

Thank you gentlemen for your quick responses! I...

Thank you gentlemen for your quick responses!
I was sweating bullets and thought the worse, I guess the overheating got my nerves a bit rattled like that heat shield.

Walt, the gauge is:...
Forum: Discovery II
07-11-2018, 08:45 PM
Replies: 387
Views: 165,584
Posted By ACEngineer

Discovery 2 LS Conversion

We've been working on an LS conversion for the Discovery 2 for the last year. All adapters were made in house and utilize the factory transmission and transfer case. We are using a stock GM LS 5.3L...
Forum: Discovery I
04-26-2018, 05:48 PM
Replies: 4
Views: 687
Posted By jackyak

Front Engine Cover Leak Write Up

Hi Everyone,

I have posted a write-up of my recent adventure in replacing the front engine cover gasket and other bits hidden behind it. Feel free to review and use, it was a success! I hope it is...
Forum: Discovery I
11-29-2017, 11:20 AM
Replies: 5
Views: 506
Posted By ihscouts

Walt, it's pretty much temperature dependent....

Walt, it's pretty much temperature dependent. Since your in a moderately cold climate in winter and the majority of wear is going to be at start up your safe running lower weight cold viscosity oil...
Forum: Discovery I
11-17-2017, 11:56 AM
Replies: 4
Views: 697
Posted By OverRover

https://cimg7.ibsrv.net/gimg/landroverforums.com-v...

https://cimg7.ibsrv.net/gimg/landroverforums.com-vbulletin/500x499/80-tumblr_ovt2jwjxns1vnhaxdo1_500_9d5dca807ec14f6d21414bcc66ac90be537f11a6.jpg

No worries, and this time of the year you might...
Forum: Discovery I
07-19-2017, 01:38 PM
Forum: Build Threads
05-09-2017, 10:20 AM
Replies: 119
Views: 22,011
Posted By FloridaRover

Thanks Walt, yes the front diff needs to be...

Thanks Walt, yes the front diff needs to be drained, the shiny collar on the half shaft (behind the CV) rides in the swivel ball seal preventing the gear oil and one shot grease from mixing.
...
Forum: Discovery I
05-03-2017, 11:56 PM
Replies: 4
Views: 1,427
Posted By fishEH

It mounts into a bullsh*t plastic trim piece. The...

It mounts into a bullsh*t plastic trim piece. The folks at my local emissions testing joint failed me because they couldn't test it because the "plug wasn't secured".
I made a mounting bracket with...
Forum: Discovery I
05-03-2017, 07:43 PM
Replies: 4
Views: 1,427
Posted By aemnky606

I had the same problem, I took JB weld and put it...

I had the same problem, I took JB weld and put it around the connector put masking tape to hold it in place as it cured. then i ran self tapping screws in from the top and bottom that just barley...
Forum: Discovery I
05-03-2017, 09:58 AM
Replies: 4
Views: 1,427
Posted By Robert Booth

I had the same problem when I bought my D1. ...

I had the same problem when I bought my D1.
The obd port on my 97 used the same lower fascia as on a d2. I installed the one from my parts truck and clipped in the obd port. It just clips into the...
Forum: Discovery I
03-29-2017, 09:46 PM
Replies: 27
Views: 12,872
Posted By notny41

Well I finally got my dash apart and the switch...

Well I finally got my dash apart and the switch out (thought I was going to break something pulling that switch out).


Here is what it looked like right after I took the cover off:
...
Forum: Discovery I
11-25-2016, 04:22 PM
Replies: 2
Views: 473
Posted By Kevin Rhodes

I bought this kit some years ago and never put it...

I bought this kit some years ago and never put it in the car it was supposed to go in. But they are pretty much all the same - looking at Amazon, you can get a pair of kits for ~$50 these days. I...
Forum: Discovery I
08-14-2016, 10:19 AM
Replies: 9
Views: 679
Posted By ihscouts

Carb cleaner works best, your downstream of the...

Carb cleaner works best, your downstream of the MAF so it won't harm it.

There are four IAC functions controlled by the ECU. Cold start, warm idle, cruise A/F mixture adjustments and decel. A few...
Forum: Discovery I
08-04-2016, 09:00 AM
Replies: 43
Views: 11,244
Posted By Best4x4

It took me no time at all to cut off the old...

It took me no time at all to cut off the old harness and splice in the new pigtail! It wasn't like working on a work bench, but it was certainly do able. Probably took me 30min from start to finish....
Forum: Discovery I
08-03-2016, 04:53 PM
Replies: 8
Views: 1,018
Posted By hankwhite

Here's the disclaimer I guess I should have...

Here's the disclaimer I guess I should have included in my first comment, (obviously if my goal was sneaky advertising I wouldn't have included some of the same photos that are on their website, but...
Forum: Discovery I
05-16-2016, 10:28 AM
Replies: 6
Views: 1,183
Posted By moosejr

Latest update, , ,changed ECU, didn't resolve it....

Latest update, , ,changed ECU, didn't resolve it. Checked every possible connection, etc. . .no problems found. Talked to a local independent rover shop, he suggested Crank Position Sensor, , which I...
12-15-2015, 11:44 AM
Replies: 9
Views: 433
Posted By FLA Rover

There's nothing I'd rather do than grab a...

There's nothing I'd rather do than grab a smartphone, laptop or calculator with hands covered in grease and grime. I keep a laminated copy on my tool box for quick reference.....
Showing results 1 to 25 of 28
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.