Land Rover Forums - Land Rover Enthusiast Forum - Search Results

 
Search: Posts Made By: mln01
Showing results 1 to 25 of 185
Search took 0.01 seconds.
Forum: Discovery II
05-31-2019, 02:43 PM
Replies: 8
Views: 659
Posted By mln01

I bought a fan wrench from Northern Tool for...

I bought a fan wrench from Northern Tool for ~$15. Good purchase.
Forum: Discovery II
05-19-2019, 07:23 AM
Replies: 7
Views: 471
Posted By mln01

Great idea! I can do the same! I PM'd the OP...

Great idea! I can do the same!

I PM'd the OP but haven't heard back. Patience!!!
Forum: Discovery II
05-11-2019, 10:33 PM
Replies: 65
Views: 8,687
Posted By mln01

It's not a Phillips, it's a Pozidrive screw. ...

It's not a Phillips, it's a Pozidrive screw.

Once you get it out, leave it out, or reinstall it only very, very loosely. There is absolutely no need to tighten it. As someone else said, the wheel...
Forum: Discovery II
05-06-2019, 10:46 PM
Replies: 11
Views: 1,145
Posted By mln01

Will you need the ECM from a 4.6? I would think...

Will you need the ECM from a 4.6? I would think so to make a setup perform optimally, but I am not certain. I'm confident someone else here will know for sure.
Forum: Discovery II
05-05-2019, 04:02 PM
Replies: 4
Views: 409
Posted By mln01

It is where an ultrasonic module mounts in some...

It is where an ultrasonic module mounts in some DII models. The ultrasonic module is part of the anti-theft system. It triggers the alarm if a window is broken. It also triggers the alarm if you...
Forum: Discovery II
05-04-2019, 11:25 AM
Replies: 8
Views: 383
Posted By mln01

I agree with Best, as usual, but R7 is AUX...

I agree with Best, as usual, but R7 is AUX circuits and R13 is the horns so they should both be installed. Do the horns work on your truck? R14 is ACE, which is uncommon but your truck may have it....
Forum: Discovery II
05-01-2019, 08:24 AM
Replies: 14
Views: 849
Posted By mln01

Well that's interesting. I used the Delphi...

Well that's interesting.

I used the Delphi software to diagnose the Three Amigos on my truck. It said right rear sensor. I battled it for months and months. The Amigos were clear for a few...
Forum: Discovery II
04-30-2019, 09:29 PM
Replies: 6
Views: 335
Posted By mln01

In my (limited) experience, misfires on all the...

In my (limited) experience, misfires on all the cylinders on one bank are caused by a problem with the upstream O2 sensor or its wiring. That was the case with my truck and with at least a few...
Forum: Discovery II
04-27-2019, 05:49 PM
Replies: 33
Views: 3,293
Posted By mln01

Plus it's the ultra-rare 6-cylinder model. Better...

Plus it's the ultra-rare 6-cylinder model. Better fuel economy than the nasty V8. And the seller accepts cryptocurrency.
Forum: Discovery II
04-24-2019, 02:20 PM
Replies: 19
Views: 747
Posted By mln01

There's a thread over on DWEB started by a guy...

There's a thread over on DWEB started by a guy who took a trip from Louisiana to Alaska four years ago. It's a good read.

https://discoweb.org/index.php?threads/alaska-and-back.91761/
Forum: Discovery II
04-15-2019, 11:56 AM
Replies: 16
Views: 694
Posted By mln01

I broke the red ring years ago and did a field...

I broke the red ring years ago and did a field repair with a silicone grommet that I sliced in half. Worked great for a years until I picked up a red ring from a boneyard truck. You also don't need...
Forum: Discovery II
04-14-2019, 04:47 PM
Replies: 16
Views: 694
Posted By mln01

Why do you think the vacuum leak is at that...

Why do you think the vacuum leak is at that location? What about it is "bad"? If it's missing the red ring you can replace just the red ring.
Forum: Discovery II
03-29-2019, 06:12 AM
Replies: 16
Views: 671
Posted By mln01

Throttle body. Get some carb cleaner....

Throttle body.

Get some carb cleaner. Remove the tube leading to the throttle body and inspect the throttle butterfly and tube. See if the butterfly is stuck open. Use the carb cleaner to clean...
Forum: Discovery II
03-18-2019, 09:31 PM
Replies: 10
Views: 547
Posted By mln01

No. The lock is not (directly) mechanical. ...

No.

The lock is not (directly) mechanical.

The only thing the key does is close an electrical switch that grounds a circuit, which in turn signals the BCU to activate the door unlock motors....
Forum: Discovery II
03-16-2019, 03:16 PM
Replies: 8
Views: 648
Posted By mln01

Yeah, looks like a bump stop. I wouldn't be...

Yeah, looks like a bump stop. I wouldn't be worried about it so much as I would be about the rusting that apparently led to it falling off your truck.
Forum: Discovery II
03-12-2019, 09:26 AM
Replies: 3
Views: 375
Posted By mln01

Why do you think the XYZ switch is the problem?...

Why do you think the XYZ switch is the problem? There are more than a dozen faults that can trigger the flashing M&S lights. Unless you have had the transmission codes read you are just throwing...
Forum: Discovery II
03-09-2019, 10:33 PM
Replies: 20
Views: 1,675
Posted By mln01

Replacing the engine mounts can seem intimidating...

Replacing the engine mounts can seem intimidating but it's really a pretty simple job. Unless you're doing some severe off-roading the stock rubber mounts are fine. The easiest answer is to buy...
Forum: Discovery II
03-09-2019, 07:29 PM
Replies: 93
Views: 10,485
Posted By mln01

If she has the old-style brake light switch the...

If she has the old-style brake light switch the plunger can be pulled out further, even if it doesn't appear it can be. I don't know about the new-style switch.
Forum: Discovery II
02-24-2019, 06:34 PM
Replies: 6,707
Views: 2,653,623
Posted By mln01

The motor mount nuts are 18mm heads, not 19mm. I...

The motor mount nuts are 18mm heads, not 19mm. I know because I once rounded one off using what I thought was an 18mm wrench that turned out to be a 19mm. Oops. Or perhaps you're talking about the...
Forum: Discovery II
02-19-2019, 12:03 PM
Replies: 22
Views: 1,167
Posted By mln01

Disco Mike had the link to what turns out to be...

Disco Mike had the link to what turns out to be GB 4x4 Radios in his signature but if you're not having any luck contacting them that's irrelevant. The AUX port they installed in the factory head...
Forum: Discovery II
02-13-2019, 01:30 PM
Replies: 6
Views: 480
Posted By mln01

Download a PDF copy of the workshop manual and...

Download a PDF copy of the workshop manual and search in it for the codes. The link to the workshop mammal is in my signature below.
Forum: Discovery II
01-30-2019, 01:56 PM
Replies: 16
Views: 763
Posted By mln01

Dude, the outside appearance of the cats has...

Dude, the outside appearance of the cats has NOTHING to do with their performance.

Be patient trying to remove the O2s. You don't say in this thread why you are replacing the O2s. What codes are...
Forum: Discovery II
01-17-2019, 07:39 PM
Replies: 7
Views: 678
Posted By mln01

Option B is worth a shot if you have The Boys...

Option B is worth a shot if you have The Boys from South of the Border but don't have easy access to a tool to read the ABS codes since in many, many cases the shuttle valve switch circuit is the...
Forum: Discovery II
01-14-2019, 08:05 PM
Replies: 11
Views: 776
Posted By mln01

If the original poster wants to upgrade the...

If the original poster wants to upgrade the alternator, a lot of forum members would recommend the 150 amp Bosch alternator from a P38A. Direct fit.
Forum: Discovery II
01-07-2019, 12:11 PM
Replies: 15
Views: 1,139
Posted By mln01

I tried the 3-D rollers but it wasn't successful....

I tried the 3-D rollers but it wasn't successful. We tried two different glues/cements but on both attempts the rollers came apart after a short period of use. I eventually ordered a new regulator...
Showing results 1 to 25 of 185
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.