Land Rover Forums - Land Rover Enthusiast Forum - Search Results

Search: Posts Made By: R0VERGUY
Showing results 1 to 17 of 17
Search took 0.00 seconds.
Forum: Discovery II
10-14-2018, 10:29 PM
Replies: 18
Views: 1,120
Posted By R0VERGUY

Have you done a parasitic draw test yet? I'm...

Have you done a parasitic draw test yet? I'm curious what reading you'll get with a battery drain over night like that.

It's a quick and easy test to do.

1)Use a screw driver to trip the door...
Forum: Discovery II
10-05-2018, 07:10 AM
Replies: 5
Views: 371
Posted By R0VERGUY

Yep, what the person above said is correct. It is...

Yep, what the person above said is correct. It is a grease fitting, but a different attachment than the others is needed to grease it. The center ball grease point is a very positive thing and a big...
Forum: Discovery II
10-04-2018, 04:11 PM
Replies: 13
Views: 743
Posted By R0VERGUY

I would start by checking for loose speed...

I would start by checking for loose speed sensors, and clean out old break dust.
Forum: Discovery II
10-03-2018, 04:23 PM
Replies: 22
Views: 2,064
Posted By R0VERGUY

I think the rule of thumb around here has always...

I think the rule of thumb around here has always been, you are good with just getting lifted springs and shocks up to 2". Anything over 2" and you should start to look into extended brake lines and...
Forum: Discovery II
12-01-2015, 10:12 PM
Replies: 7
Views: 2,650
Posted By R0VERGUY

Nice write up. Might I suggest buying the kits...

Nice write up. Might I suggest buying the kits that have the o-rings, as well as the filter baskets and end caps maybe? Only $24.50

Rover V8 Fuel Injector Repair Rebuild Service Kit Orings...
Forum: Discovery II
11-05-2015, 07:25 AM
Replies: 16
Views: 953
Posted By R0VERGUY

F.F.S Well I replied to the part where...

F.F.S



Well I replied to the part where you said, "The Amigos will remain until the issue causing them has been resolved. Once the ECU determines the problem is gone, it extinguishes the...
Forum: Discovery II
10-31-2015, 12:33 PM
Replies: 61
Views: 3,797
Posted By R0VERGUY

Your issue sounds like a classic case of a failed...

Your issue sounds like a classic case of a failed Crankshaft position sensor. It's a fairly cheap part but it's hard to reach up and get to the plug. I think you can confirm a dead Crank sensor by...
Forum: Discovery II
10-06-2015, 12:21 PM
Replies: 5
Views: 658
Posted By R0VERGUY

-I'm not sure if the fuel pump stays powered with...

-I'm not sure if the fuel pump stays powered with the key in the on position like that but if it does then maybe you burned up the pump. Check the fuses first and listen back by the pump while...
Forum: Discovery II
09-29-2015, 02:42 PM
Replies: 23
Views: 12,988
Posted By R0VERGUY

Forum: Discovery II
09-21-2015, 09:49 PM
Replies: 4
Views: 396
Posted By R0VERGUY

usually the LH head (drivers side) is the hard...

usually the LH head (drivers side) is the hard one to get off because of the rear bolt. When you say you have the LH head off it can be confusing because if you are standing in front looking back...
Forum: Discovery II
09-11-2015, 10:22 PM
Replies: 12
Views: 2,949
Posted By R0VERGUY

I remember hearing about a way to bypass your...

I remember hearing about a way to bypass your brake light switch by jumping or crossing your brakes lights or something. The problem usually starts when the brake light switch on the brake pedal...
Forum: Discovery II
09-10-2015, 03:21 PM
Replies: 16
Views: 1,327
Posted By R0VERGUY

I would save the money it would cost to go dual...

I would save the money it would cost to go dual flow for other things down the road. If you want to improve air flow then buy a snorkel kit. It will get the intake up high and out of the stock...
Forum: Discovery II
09-03-2015, 09:44 PM
Replies: 25
Views: 1,519
Posted By R0VERGUY

I think that we all have dreams of blowing our...

I think that we all have dreams of blowing our disco's up and moving on with our lives. I just have too much money dumped into mine by this point to do that. If there is ever a time to do it it's...
Forum: Discovery II
09-03-2015, 01:43 PM
Replies: 5
Views: 530
Posted By R0VERGUY

Just to add to this thread. I bought this set...

Just to add to this thread. I bought this set just for the valve cover bolts. All my other sockets (even the 1/4" ones) were to fat to fit in the recess in the valve cover, but these were skinny...
Forum: Discovery II
08-27-2015, 05:23 PM
Replies: 64
Views: 9,780
Posted By R0VERGUY

You might want to take a close look at the fuse...

You might want to take a close look at the fuse box under the hood. Maybe it got water in it and was slowly going out as you drove it after you got it unstuck. I really think that you have some...
Forum: Discovery II
08-23-2015, 09:14 AM
Replies: 64
Views: 9,780
Posted By R0VERGUY

-Well if you find you have good PSI at the fuel...

-Well if you find you have good PSI at the fuel rail and rule that out also I'd have to start looking at the ECU, bad fuse box, or something electrical. Is this the Disco that sat in the mud for 5...
Forum: Discovery II
08-23-2015, 12:19 AM
Replies: 11
Views: 1,282
Posted By R0VERGUY

If you have SAI it makes taking the upper intake...

If you have SAI it makes taking the upper intake off a little more of a pain in the ass but it's not a super hard job. I would rather pull the upper intake then mess with the motor mounts and drop...
Showing results 1 to 17 of 17


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.