Land Rover Forums - Land Rover Enthusiast Forum - Search Results

 
Search: Posts Made By: mollusc
Showing results 1 to 25 of 500
Search took 0.18 seconds.
Forum: Discovery II
06-21-2019, 03:52 PM
Replies: 9
Views: 708
Posted By mollusc

yes, the nuts for the spare are different. the...

yes, the nuts for the spare are different. the threads go all the way through the internal hole because the studs are longer. on the regular wheel nuts the thread stops short so you're likely to...
Forum: Discovery II
06-21-2019, 06:27 AM
Replies: 9
Views: 435
Posted By mollusc

i have a very similar sound after doing the head...

i have a very similar sound after doing the head gaskets on mine. i never heard the engine run before i did them so i don't know if the noise developed then, but i'm pretty sure that it's not a...
06-20-2019, 08:24 PM
Replies: 2
Views: 139
Posted By mollusc

you'll also need the refrigerant lines that run...

you'll also need the refrigerant lines that run from the main system.
i have all of it but i don't have any time to harvest it. haven't even been able to start pulling the bits of that truck that i...
Forum: Discovery II
06-17-2019, 03:06 PM
Replies: 12
Views: 810
Posted By mollusc

the relocator may be more than capable of...

the relocator may be more than capable of handling the momentum forces of a large, heavy mass moving up and down as you travel. it looks pretty solid. but you've extended the centre of gravity of...
Forum: Discovery II
06-16-2019, 05:41 AM
Replies: 12
Views: 810
Posted By mollusc

get rid of the relocator. go back to just the...

get rid of the relocator. go back to just the original mount but flip it upside down. drill two new holes for the mounting studs and rotate the rear wiper on its spline so that it doesn't hit the...
Forum: Discovery II
06-15-2019, 07:12 PM
Replies: 12
Views: 810
Posted By mollusc

the overhang on the spare is huge. that's going...

the overhang on the spare is huge. that's going to increase the bending moment significantly (i.e. massive increase in stress on the mounting bolts).
Forum: Discovery II
06-15-2019, 07:09 PM
Replies: 11
Views: 646
Posted By mollusc

i find that putting it into sport mode works best...

i find that putting it into sport mode works best for towing, but i'm not pulling anything as big as that (flat trailer with a couple of motorcycles on it).
06-14-2019, 05:32 AM
Replies: 9
Views: 440
Posted By mollusc

i couldn't spot it during a quick check early...

i couldn't spot it during a quick check early this morning, but i did find the plastic nuts! will try to look some more later today if i get a chance.
Forum: Discovery II
06-13-2019, 09:51 AM
Replies: 6,718
Views: 2,661,120
Posted By mollusc

is that a piston skirt? how would that even...

is that a piston skirt?
how would that even happen??
06-13-2019, 06:39 AM
Replies: 9
Views: 440
Posted By mollusc

i think the one in my parts truck is still good. ...

i think the one in my parts truck is still good. i can check tomorrow and let you know.
Forum: Discovery II
06-10-2019, 11:50 AM
Replies: 12
Views: 1,313
Posted By mollusc

i don't think all trucks have a sensor in that...

i don't think all trucks have a sensor in that area. my '99 doesn't seem to have one -- only the sensor up behind the alternator.
Forum: Discovery II
06-07-2019, 11:54 AM
Replies: 93
Views: 10,572
Posted By mollusc

the time it will take to replace the hose depends...

the time it will take to replace the hose depends very much on which hose it is, but i can't see any of them really taking that long to do.
i would definitely get something more solid from them than...
Forum: Discovery II
06-07-2019, 06:35 AM
Replies: 3
Views: 399
Posted By mollusc

or someone might have put the wrong bulbs in.

or someone might have put the wrong bulbs in.
Forum: Discovery II
06-06-2019, 10:12 PM
Replies: 3
Views: 399
Posted By mollusc

the trailer light illuminates automatically when...

the trailer light illuminates automatically when extra load is detected on the turn signal circuit. it goes on and off as the turn signal goes on and off. at least on my truck, when the brake is...
Forum: Discovery II
06-06-2019, 10:06 PM
Replies: 10
Views: 941
Posted By mollusc

not sure if it's the cause of your problem, but i...

not sure if it's the cause of your problem, but i don't think that's the bleed order according to the rave manual. perhaps there's a reason why they say rf - lf - rr -lr.
06-06-2019, 08:19 AM
Replies: 2
Views: 291
Posted By mollusc

might want to say where it is.

might want to say where it is.
Forum: Discovery II
06-05-2019, 11:42 AM
Replies: 13
Views: 987
Posted By mollusc

hub sensor shouldn't affect communication with...

hub sensor shouldn't affect communication with slabs. i've replaced a couple of hubs because of bad sensors and they didn't throw all those lights.
have you tried pulling the slabs unit and...
06-05-2019, 08:19 AM
Replies: 5
Views: 326
Posted By mollusc

that's a terrafirma

that's a terrafirma
Forum: Discovery II
06-04-2019, 10:00 AM
Replies: 14
Views: 1,230
Posted By mollusc

that's a page grab from the rave manual. ...

that's a page grab from the rave manual. download links are all over the place.
Forum: Discovery II
06-02-2019, 06:10 PM
Replies: 2
Views: 429
Posted By mollusc

did you program your slabs unit to indicate that...

did you program your slabs unit to indicate that the rear suspension is now coils instead of air springs?
Forum: Discovery II
06-01-2019, 10:55 AM
Replies: 2
Views: 413
Posted By mollusc

sounds like your alarm system may not be arming...

sounds like your alarm system may not be arming because one of its sensors is open, so the truck is locking and notifying you that the alarm has an error. does the dashboard alarm indicator light do...
Forum: Discovery II
05-30-2019, 09:00 AM
Replies: 12
Views: 1,420
Posted By mollusc

and is that a '64 impala too?

and is that a '64 impala too?
Forum: Discovery II
05-28-2019, 09:28 AM
Replies: 2
Views: 356
Posted By mollusc

only use walker brand o2 sensors in a disco. ...

only use walker brand o2 sensors in a disco. they're not the cheapest ones but they're usually cheaper than bosch, and they seem to be the most reliable.
do you have a code reader that will show...
Forum: Discovery II
05-28-2019, 06:36 AM
Replies: 10
Views: 806
Posted By mollusc

i find everything using the search function...

i find everything using the search function rather than trying to go by category.
Forum: Discovery II
05-27-2019, 04:35 PM
Replies: 10
Views: 803
Posted By mollusc

i didn't find it was that big of a deal to leave...

i didn't find it was that big of a deal to leave the crossmember in place. more hassle to remove it than it was to leave it alone.
i do have a slight lift (about 1") which might be giving me more...
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.