Intro- trail tailor
#11
Andrea got the table wired up and ran a couple of sample cuts they uploaded at the factory. Now to finish the set up, get it positioned and fill it up with 300 gallons of water and chemicals.
Straight off the table and didn't clean these up. Still need a bit more dial in on the thinner material.
I should be up and running again by the end of next week. I have a RR sport coming in for a few custom things next week as well. This will be an R&D build so it'll take a bit. Sliders, hidden winch mount and through bumper cover rear swing arm.
J
Straight off the table and didn't clean these up. Still need a bit more dial in on the thinner material.
I should be up and running again by the end of next week. I have a RR sport coming in for a few custom things next week as well. This will be an R&D build so it'll take a bit. Sliders, hidden winch mount and through bumper cover rear swing arm.
J
#12
The following users liked this post:
Trail-Tailor (11-16-2017)
#14
#15
A little further on the shop. 3-4 more days and I can start burning wire again. Have to cut all the lower shelves for the tables so I can unload the last 2 pallets of misc tools and other supplies.
Press brake arrives Mon/Tues per freight tracking and a steel stocking order will arrive next week as well.
One of the guys from NCLR dropped off his RR Sport this morning. It'll be receiving a hidden winch, front and rear skids, sliders and a through cover rear swing arm w/ tire carrier and ladder.
J
Press brake arrives Mon/Tues per freight tracking and a steel stocking order will arrive next week as well.
One of the guys from NCLR dropped off his RR Sport this morning. It'll be receiving a hidden winch, front and rear skids, sliders and a through cover rear swing arm w/ tire carrier and ladder.
J
#16
#18
#19
#20