Welcome to the Land Rover Forums - Land Rover Enthusiast Forum.
If this is your first visit, be sure to check out the FAQ by clicking the link above.
You may have to register before you can post: click the register link above to proceed.
To start viewing messages, select the forum that you want to visit from the selection below.
I bought a black 1995 Disco with the intentions of putting replacement floor panels in it but have decided I could use the money for another project instead. This would be a good project/trail truck for somebody who is proficient with welder. The truck has 1685xx miles and the only reason I havent parted it or sold it to somebody to part it is because of how well the truck runs. I drove it from Joppatown MD to York PA bout an hour and 15 mins no problem. Drove it around town while doing the engine swap on my 96. No check engine light, only ABS light. It is not losing any coolant or oil, transmission shifts fine, transfer case is a but touchy I believe it is missing the solenoid that prevents you from shifting it while in gear. It has a 2" lift, very low milage 245/75 long trail T/A's. It has drilled and slotted rotors which I think make a funny noise when braking, may also be the rust. There is the normal surface rust on this truck but the frame and the rest of the body besides front floor panels are solid. The interior is the only bad part. It needs new floor panels from the firewall to where the backseats start. Looks like water ran down A pillar and puddled on the floor. The previous owner replaced the head liner thinking it would fix the issue, needless to say I doubt it but I havent seen any water puddling either. The project was started by PO so the seats are not attached to the floor at this time. I believe heater fan is dead or it needs a new fuse havent had a chance to work on it yet. Needs a turn signal and a brake light in the rear, all the front lights works great. It does have a small exhaust leak but isnt bad at all.
Any questions or if you want pics let me know. $1000 or best offer takes it. May also trade for AR-15 or 180amp or higher MIG + Cash. If it doesnt sell in the next 2 weeks I am going to part it.
Teaser pic, it's the one on the right - PM or email me for more pics
__________________ 96 Disco - 35's, lockers, 3-link etc. 95 Disco Tray Back project - 265/75/16's chopped and bobbed
I MIGHT be moving to Tallahasee when our lease is up. SO I am leaning out back to one rover and will probably end up re-gearing and running 35's+ (gonna have to if I move down south) and/or will keep saving for another project. Trayback or bobbed rangie in the future isnt out of the question..
__________________ 96 Disco - 35's, lockers, 3-link etc. 95 Disco Tray Back project - 265/75/16's chopped and bobbed
But if no one else snatches it up, I may want to take it off your hands......
lol yea I had some other pictures on my phone but none hosted online.
Nobody else has offered yet. Just sent pics to a guy on dweb. If you want more pics let me know - I'd be willing to drive it an hour or so to meet up if you want it.
__________________ 96 Disco - 35's, lockers, 3-link etc. 95 Disco Tray Back project - 265/75/16's chopped and bobbed
1995 d1 $1000 OBO
) and/or will keep saving for another project. Trayback or bobbed rangie in the future isnt out of the question..
