Land Rover / LR2 Today 03:03 PM
I'm not aware of using spacers like this as a fix (hack?), but O2 sensors should not fail after three years unless they were substandard quality to begin with.
Using OBD2 live data, check your...
wlindsey@gmail.com
Thread Starter
Land Rover / 2020 Defender Today 02:53 PM
Now that the KO3 is available for the 19” rims, any thoughts on whether 20” is still preferred?
Land Rover / 2020 Defender Today 02:11 PM
Hah! Great story and thanks for sharing. I can certainly relate as a Dad!
Myron
Land Rover / 2020 Defender Today 12:58 PM
Quality Superchargers has a storefront on ebay where they sell a puller that will work. They also have a video around the install where they use a hotplate found on Amazon to heat up the pulley...
Land Rover / 2020 Defender Today 11:47 AM
Finally found some time to get out and enjoy some trails. Was missing the friend to take any good action shots.
...
Land Rover / Discovery II Today 09:58 AM
It seems to me a full list of service should be performed again.
Transmission: Did you do a full drain by dropping the pan and do a new filter? If not, that should be done. My understanding is...
Land Rover / 2020 Defender Today 09:46 AM
As a preventative measure, I applied some Shin Etsu grease to the existing grommets. Hopefully it will help ease the removal and reinstallation of the engine cover and thus will prevent the grommets...
Acpantera
Thread Starter
General Land Rover Forums / New Member Introduction Today 09:36 AM
Hi folks, the wife and I were looking to upgrade our tow vehicle from a Hyundai Santacruz XRT with a 5000# max tow rating to something at least 50% more cable because our Travel Trailer is right at...
Land Rover / New Discovery V Today 08:11 AM
I take mine to RAW every year and typically see one other each year. Trying to get to MAR this year with another D5. I need to get to Uwharrie next year!...
Land Rover / 2020 Defender Today 12:15 AM
A lazy person does the work twice.
Had I been not as lazy and lifted those strips, I'd have figured what I'm looking for - the second photo. I got thrown off by the fact that the edges didn't have a...