Land Rover Forums - Land Rover Enthusiast Forum

Land Rover Forums - Land Rover Enthusiast Forum (https://landroverforums.com/forum/)
-   Discovery II (https://landroverforums.com/forum/discovery-ii-18/)
-   -   Entire Dash Cluster not working (https://landroverforums.com/forum/discovery-ii-18/entire-dash-cluster-not-working-20295/)

tomfraser Mar 3, 2009 01:56 PM

Entire Dash Cluster not working
 
My speedometer, odometer, gas guage, trip miles, tachometer, engine temp, diff lock light, and other lights do not work

my turn signal does, and my high beams does


the connections are all good at the cluster, not sure where they go though


any ideas?

tornado_735 Mar 3, 2009 02:00 PM


Originally Posted by tomfraser (Post 105438)
My speedometer, odometer, gas guage, trip miles, tachometer, engine temp, diff lock light, and other lights do not work

my turn signal does, and my high beams does


the connections are all good at the cluster, not sure where they go though


any ideas?

Check the fuses. If the dash is electronic (IDK if it is) then a fuse could cause that. Had it happen to my parents car.

tomfraser Mar 3, 2009 02:02 PM

you know what I think about fuses ;)

going to check now

tomfraser Mar 3, 2009 02:06 PM

all fuses good

tornado_735 Mar 3, 2009 02:13 PM

Knowing those rascally british electricians, you might want to check you right rear marker light. It might have burned out and took your dash with it ;) lol!

tomfraser Mar 3, 2009 02:19 PM


Originally Posted by tornado_735 (Post 105444)
Knowing those rascally british electricians, you might want to check you right rear marker light. It might have burned out and took your dash with it ;) lol!

lol

if anyone has any ideas please post as I have to go soon

tomfraser Mar 3, 2009 02:56 PM

going through the rave manual those things are not all on one harness, so i'm kinda nervous about this

Rover Chris Mar 3, 2009 03:01 PM

are the gauges not working or the illumination on the gauges? I would check the ground in the kick, that's where they should be grounded.

Disco Mike Mar 3, 2009 03:43 PM

Looking at a cracked circuit board, I bet.

tomfraser Mar 3, 2009 04:49 PM

Alright... got the multimeter and tested pin 7 on connector c207, no 12v

checked for 12v at fuse 14, got it

so somewhere in between i have a problem, I think i'm just gonna run a new wire so I don't have to disassemble the dash though


All times are GMT -5. The time now is 05:49 AM.


© 2026 MH Sub I, LLC dba Internet Brands