land rover 90 p38 4.0 V8 install
#1
land rover 90 p38 4.0 V8 install
Hello Everyone,
I have recently started this project installing a 4.0 v8 from a p38 into my land rover 90, however after completing the wiring the car is unable to start, the display shows "key code lockout" I believe this is the immobilizer from the becm, does anyone know how to bypass the immobilizer? or if anyone has done a similar project how did you overcome this problem?
I have 2 keyfobs, ignition, becm, Engine ECU and the security codes, but still it will not start, any help will be highly appreciated. Thank you
I have recently started this project installing a 4.0 v8 from a p38 into my land rover 90, however after completing the wiring the car is unable to start, the display shows "key code lockout" I believe this is the immobilizer from the becm, does anyone know how to bypass the immobilizer? or if anyone has done a similar project how did you overcome this problem?
I have 2 keyfobs, ignition, becm, Engine ECU and the security codes, but still it will not start, any help will be highly appreciated. Thank you
Thread
Thread Starter
Forum
Replies
Last Post
robdis96
Discovery II
12
02-22-2013 07:07 PM
rangeroverhse
General Range Rover Discussion - Archived
1
07-23-2008 08:15 AM