Welcome to the Land Rover Forums - Land Rover Enthusiast Forum.
If this is your first visit, be sure to check out the FAQ by clicking the link above.
You may have to register before you can post: click the register link above to proceed.
To start viewing messages, select the forum that you want to visit from the selection below.
1990 RR, 110k Miles. A couple months ago I was driving it and pulling into my driveway I smelled smoke. Opened the hood and the passenger side O2 sensor was smoking, glowing red. I finally got around to it today and replaced it with a NTK 24024. It runs fine but is still smoking. The O2 sensor isn't glowing or anything, and the smoke is a lot less. In fact, It's hard to tell if it's coming from the O2 sensor at all, but it's on that side and low. Doesn't smell completely electrical either, sort of an electrical meets carbon smell. Ideas? Wiring leading up to it looks fine...
Need Parts? paulgrant@mac.com, or 203-770-1699 willtillery@roverguy.com, or 434-251-9331
Paul PTSchram 260-804-0458
PM Marty(Drillbit)[url]http://www.landroversonly.com/forums...o=newpm&u=5940
British Parts of Utah, http://www.bputah.com/
Lucky8, http://lucky8llc.com/
While my D1 does not report cat temp to my scanner (I don't think it does), my Kia does, about 1350 degrees when running. That'll will certainly smoke any oil drip...