Worlds longest slowest 110 build thread
#121
#122
I have the old one in the center console. I'm switching to LED lights for all those so I'm not to worried about them.
Modified the rear door tire carrier to accept a aluminum wheel. Found surface rust every where under the trim panel. So cleaned treated primed and painted that. Then resealed the rear window for good measure. Than went back to work on mounting the freelander seats in the front. Had to bring the wife out for final approval of the seat comfort and I'm all set to weld the bracket slider combo now.
I'm sure you have seen a rusty tailgate before so here is a quick shot of the seat.
Modified the rear door tire carrier to accept a aluminum wheel. Found surface rust every where under the trim panel. So cleaned treated primed and painted that. Then resealed the rear window for good measure. Than went back to work on mounting the freelander seats in the front. Had to bring the wife out for final approval of the seat comfort and I'm all set to weld the bracket slider combo now.
I'm sure you have seen a rusty tailgate before so here is a quick shot of the seat.
#123
#125
#126
Ok so I went ahead and mounted up a roof light bar that I picked up.
I put a couple of old Hella lights I had lying around and put them on it. It has 4 light mounts. I'm debating on 4 round lights up top or a 42 or 52 inch led light bar.
I know the light bar will draw less juice, and produce way more light but I'm not sure if it will look right.
No pics obviously with a light bar but here are a few with the 2 rounds on it.
Here is the LED light bar I have in mind.
I put a couple of old Hella lights I had lying around and put them on it. It has 4 light mounts. I'm debating on 4 round lights up top or a 42 or 52 inch led light bar.
I know the light bar will draw less juice, and produce way more light but I'm not sure if it will look right.
No pics obviously with a light bar but here are a few with the 2 rounds on it.
Here is the LED light bar I have in mind.
Last edited by ArmyRover; 05-03-2015 at 04:36 PM.
#127
#129
#130
Well I got the light bar all cleaned up as it had a bit of rust on the gutter mount points. Wire wheeled, treated, zinc primer and 6 coats of matte black plasti dip.
Thought I took pictures, but I apparently forgot. Hopefully at the end of the month the tear down and full dip job will happen. I'm taking a week off so hopefully it will be enough time.
Thought I took pictures, but I apparently forgot. Hopefully at the end of the month the tear down and full dip job will happen. I'm taking a week off so hopefully it will be enough time.