Hi all you guys in the landie chat forum. Dont know if I am in the right forum but my boyfriend has an old landie 90 that he is putting through an MOT but it has failed on a couple of bits that he is putting right himself and little old me is helping, sort of.
Have any of you any idea how to squeeze the railko push and housing into the swivel pin bearing housing as its proving to be quite difficult. Wondered if there was some sort of knack to it.
Thanks guys

 

First off, what year is the vehicle?

 

Hi there

Not sure how that would be relevant therefore maybe you could explain? Its about 25 years old I think so quite an oldie.

He is trying to put one part into the other and from what I can see it just doesnt seem to be fitting.

Thanks in advance