I have a Tekonsha Prodigy brake controller I want to use in the Disco and the best place to locate it is on the dash top above the right driver's heater vent. I poked a wire down the radio cooling vent opening behind the rubber mat on the dash as that looked like a good place to feed the wires, but I couldn't get it come out down below or over in the fuse panel area - must be a duct under there.

Has anyone run wires from the top of the dash to the fuse area? Any photos if so? Any suggestions on how or where to do it? Or what has to come apart to do it?

 

Take out the instrument shroud and cluster, should open up a lot of room.