Rock Sliders, Buy or Make?
#11
#13
I made my own its not that hard but they are straight and dont follow the lower body line good ( https://landroverforums.com/forum/di...sliders-33950/ )
Last edited by Long Haul; 06-24-2011 at 02:07 PM.
#15
I just used a sawzall to cut everything a drill and a mig welder, nothing special. If i was to do it again I would make a couple cuts to angle the body line. I added a couple frame mounts since I did them ( I'll try to get a couple pics). They were fine but I noticed they were starting to bend up a little from abuse but nothing serious. As far as the length of them nobody make them short enough to work for my cutout flares so you'll have to measure for length.
Last edited by Long Haul; 06-24-2011 at 02:41 PM.
Thread
Thread Starter
Forum
Replies
Last Post