best headunit setting
#11
well im not looking to add a box due to the limited room, i have the fold out seats and i do use them, the rover is the party van lol. as for the amp i dont know how to replace it with a higher one is it simple? id rather do the walmart solution if it actually sounds good. do you know what size and what brand it is. anyone have this on here?
#12
#14
depends on how you are at that kind of stuff, you would need to run a power cable from the battery to wherever you are mounting the amp, you would need to run rca cables and remote wire from your head unit to wherever you are mounting the amp, you would need to "tap" a good ground near the amp, and then run your speaker wires from the amp into the back door. I mounted my power cable distribution block under the center console storage box, there was plenty of room there and you could probably fit a pretty small amp there. I removed my CD changer from under the passenger seat and mounted my amp there (tapped my ground in the floor at the back side of the seat), and ran my speaker wires back all without too much trouble. my sub box is where my passenger jump seat used to be so I didn't have to go into the door but it shouldn't be too much trouble do that.
one thing to remember is your grommet on the firewall that you will run power through is on the drivers side and your battery is on the passenger side so make sure you have enough power cable to go across the back of the engine well and then to wherever you mount your amp. This is why I mounted my power distribution block under the center console. I will eventually run an 8AWG power wire to the back and mount a fuse box back there so I can have extra power ports in the back for whatever I may need (spotlight, air compressor, or any other 12 volt camping or emergency supplies I may want to have back there)
one thing to remember is your grommet on the firewall that you will run power through is on the drivers side and your battery is on the passenger side so make sure you have enough power cable to go across the back of the engine well and then to wherever you mount your amp. This is why I mounted my power distribution block under the center console. I will eventually run an 8AWG power wire to the back and mount a fuse box back there so I can have extra power ports in the back for whatever I may need (spotlight, air compressor, or any other 12 volt camping or emergency supplies I may want to have back there)
Last edited by Rover Chris; 12-13-2009 at 04:04 AM.
#15
#16
found this
http://www.walmart.com/catalog/produ...ct_id=12518831
http://www.walmart.com/catalog/produ...ct_id=12518825
whats the highest wattage the stock amp can handle?
http://www.walmart.com/catalog/produ...ct_id=12518831
http://www.walmart.com/catalog/produ...ct_id=12518825
whats the highest wattage the stock amp can handle?
Last edited by Classklown90; 12-13-2009 at 11:08 AM.
#18
#20