Questions on Front Brush Bar Installation on 2003 Disco
#1
Questions on Front Brush Bar Installation on 2003 Disco
I just received the front brush bar for my 03 Disco from Rover North. After reading the instructions I was surprised to find that the front bumper needs to be removed and have 2 holes cut into it for the installation. I asked Rover North specifically if any modification needs to be done to the vehicle before the purchase but I never got a straight answer. Now for those who have experience with this installation on 03/04 vehicles:
1] Does the bumper need to come off? Can the holes be opened while the bumper is on the vehicle?
2] There are only pictures (no text) in the installation instruction. It looks like I'd have to remove the front grille, bumper, and a U-shaped piece behind it. Do I need to remove the fog lights and headlamp washers also? Anything special I should watch out for before tearing into the front? Any pointers/tips for this installation?
Thanks much in advance
Alan
1] Does the bumper need to come off? Can the holes be opened while the bumper is on the vehicle?
2] There are only pictures (no text) in the installation instruction. It looks like I'd have to remove the front grille, bumper, and a U-shaped piece behind it. Do I need to remove the fog lights and headlamp washers also? Anything special I should watch out for before tearing into the front? Any pointers/tips for this installation?
Thanks much in advance
Alan
Thread
Thread Starter
Forum
Replies
Last Post
kpl1228
Discovery II
6
11-20-2010 11:05 PM
warrencrescent
General Range Rover Discussion - Archived
0
11-11-2010 04:26 PM
Disco Alan
Discovery II
1
07-14-2006 01:28 PM