Ultra Gauge page one display
#1
#2
#3
I use 4 gauges per page so the numbers are big and easy to read. On my 1st page I have coolant temp, intake temp, engine load and MPH. On the 2nd page I have the 4 o2 sensor readings. That's about all I use.
I did change my coolant temp warning to come on at 216 (I think the factory setting is around 240-250) so I could pull over before it's to late. I have the 180 t-stat and run at about 194-197 and never get over 204 even on the hottest San Antonio summer days in traffic, so if I ever hit 216 then I know there is a problem. I'm not going to wait until it hit 250 to pull over and check things out.
I did change my coolant temp warning to come on at 216 (I think the factory setting is around 240-250) so I could pull over before it's to late. I have the 180 t-stat and run at about 194-197 and never get over 204 even on the hottest San Antonio summer days in traffic, so if I ever hit 216 then I know there is a problem. I'm not going to wait until it hit 250 to pull over and check things out.
#4
#8
I'm glad this thread was posted! I'm a new Disco II owner ('01, 125+k miles) and have already learned a huge amount from this BB! My most recent upgrade is the UG, installed no problem, everything OK, except I'm having a huge problem customizing the display! I want page 1 to read like Jared9220 describes, but nothing I do changes what is on the display! Following the manual to the letter, NG! Now, I thonk it has affected the factory fuel gauge, so I am going to do the 'Force Protocol' later today! Any suggestions/recommendations ?
#9
...I'm having a huge problem customizing the display! I want page 1 to read like Jared9220 describes, but nothing I do changes what is on the display! Following the manual to the letter, NG! Now, I thonk it has affected the factory fuel gauge, so I am going to do the 'Force Protocol' later today! Any suggestions/recommendations ?