Hey guys,

need both front and rear of these (both sides):





They are too expensive brand new. Looking for used ones but in good condition.

Thanks!

 

These are tough to find even new. I've been looking for replacements for all the drip rail trim for a while myself. These are the part numbers, for reference:

AWR4418 Center rear drip rail
DBC101630 Center left drip rail
DBC101620 Center right drip rail
DBC101400 Right rear rain finisher
DBC101410 Left rear rain finisher
DBC101690 Left front rain finisher
DBC101680 Right front rain finisher

 

I wonder if we could model these and have these 3d printed by a service like this: Miniatures - Shapeways 3D Printing

There are some auto parts among the examples on this page, and judging by the size of these parts it'd probably somewhere in the range of $20 a pop, if I had to guess.

I've never done 3d modeling but would be willing to give it a shot.

Edit: actually, these auto parts are for miniature models. Lol. Anyway, it still could be maybe economical in principle, given that the actual parts are about $100 each.

 

I can help you guys out. I live out here in southern California smack in the middle of at least 8 junk yards. In fact, took a look at 7 or 8 Discos, p38s, and an RRC today. Sorry to brag. Anyways, I'll sell it for what I get it for plus the $3 admission (up from $2! Ha) and postage. I can tell you right now a single part is about $2-5.

Let me know what you guys need and I'll try to hook it up. The parts you're asking about and similar stuff is readily available. Front bumpers, full roof racks, some off road accessories, and freakin horn buttons are unicorns...they don't exist.

 

If you get any orders lined-up, I would like for you to get me 1 or 2 of the SAI pump mounting bolt and bushing. There are 3-4 on the unit, the size of pinky finger-tip.

 

And this decal from the front fender of 2004 D2

 

ahh that broken rubber mounting on the SAI pump. I have the same issue, ended up using a twisty tie. I'll see what I can find.

 

Cool.

 

BMW uses the same part for the oil filter housing.

I replaced them with a rubber stopper and stainless bolt from Homedepot for about $2 each.

 

I am in need of a right and left front upper drip rail Sir(the chubby pieces), if you can accommodate me I can give you my email or cell number, pm me and we can do this> i appreciate your willingness to help brothers out on here.