what is your favorite upgrade you have done to your DII
#31
Thanks, It took me some time. I used Arm-A-Seal to clear coat it. The veneering was easy. I just traced out the original door panel and cut it with a jig saw. The walnut handle was not to hard either. I'm a furniture builder at heart.
#32
Sorry for the resurrection but... I'll say my LED lights inside and out. Very different than other Disco II's out there. I got the extremely bright LED hyper flash effect when using the turn signal but it lets you know that... HOLD UP FOOL! I'm stopping and turning!
Last edited by JUKE179r; 11-15-2016 at 03:34 PM.
#34
So far it's my Auber gauges for water temp, oil temp, oil pressure and fuse panel
In that picture is also an alarm that goes off on low oil pressure or high water temp.
Also a GROM unit - microphone drilled into the dash, and usb port drilled into the switch blank
And the ultragauge installed into the face of the ash tray. Secret compartment behind
In that picture is also an alarm that goes off on low oil pressure or high water temp.
Also a GROM unit - microphone drilled into the dash, and usb port drilled into the switch blank
And the ultragauge installed into the face of the ash tray. Secret compartment behind
Last edited by Jeff Blake; 11-15-2016 at 06:48 PM.
#35
#37
Can you provide a link or information on how this MOD was done?
Thanks In Advance.
Thanks In Advance.
The following users liked this post:
Glatt (06-15-2019)
#38
Thanks, yeah I have a buggy wash really close to the house so moment it's back from wheeling gets power washed everywhere. People usually don't believe me when I'm getting to trails that I'm going to put my rig through them.
#39
#40