I have the following issue with my 2010 Range Rover. When am driving it, it will gave me massage on Dash Board that Gear Box fault and the Gear will not select anymore until I turn off the ignition and start again before it will start selecting.

When I ran diagnostic on it, I get TCM fault code P2704 "Transmission vision Element E apply time range/performance".

Any idea of what this is about and what can be done?

 

According to Land Rovers Fault code listing in Topix the code P2704-07 indicates an internal mechanical failure. Topix recommends replacement as ZF internal parts are hard to come by but check with your local transmission shop to see if they have the parts and knowledge to repair a ZF