Access Height - three presses
#1
Access Height - three presses
Hi there, I've recently purcased a 2014 L494 Diesel in the UK, I had an L320 a good few years back, so I'm not totally new to RRS ownership. My mild issue is that dropping to access height when stationary causes the car to bounce back up to Off-Road height. Whilst crawling, it drops to access fine. All other suspension actions work perfectly and in a timely manner. I can get it to access height when stationary, but this involves pressing the suspension lower button three times, first press to start the process, then a second time as soon as it starts to bounce up to off-raod height, and then a third when it tries to do that again....finally the rear suspension units will lower. The fronts move rapidly, it just seems the rears are reluctant.
I've changed the brass exhaust vent fitting as the original was nasty, and I have just changed the exhaust solenoid this morning, but the behaviour persists. Parts are super cheap, so may also get the relay and swap that over too.
Anybody else managed to get to the bottom of this behaviour yet?
Many thanks in advance
Ben
I've changed the brass exhaust vent fitting as the original was nasty, and I have just changed the exhaust solenoid this morning, but the behaviour persists. Parts are super cheap, so may also get the relay and swap that over too.
Anybody else managed to get to the bottom of this behaviour yet?
Many thanks in advance
Ben
Thread
Thread Starter
Forum
Replies
Last Post
bhorwhat
General Range Rover Discussion - Archived
0
09-09-2009 06:41 AM