Asking for input on Heads!
#1
Asking for input on Heads!
I have the ability to get heads for 4.0 and 4.6 and have a valve job, machined and checked out for cracks.
I was wondering if it would be beneficial to offer this service and this is what I was wondering so please give me feed back.
For a set of heads machined, valve job and clear of cracks would $500 be reasonable. There is no core charge but I maybe able to work something out if your heads are not cracked?
Do you think this would be advantageous to offer to the forum or am I wasting time?
I was wondering if it would be beneficial to offer this service and this is what I was wondering so please give me feed back.
For a set of heads machined, valve job and clear of cracks would $500 be reasonable. There is no core charge but I maybe able to work something out if your heads are not cracked?
Do you think this would be advantageous to offer to the forum or am I wasting time?
Last edited by NCguy; 10-06-2013 at 11:34 AM. Reason: CHange heading
#2
Will Tillery already does something similar, and he can also provide the head gasket sets and bolts at the same time. You might check his posts over on discoweb to compare prices. If you are cheaper you might have a some success. If you aren't most people would probably buy from Will because he is well known and trusted in the Land Rover community.
#6
It doesn't sound TOO high considering no core. I don't recall what Will charges. I know his do have a core because people weren't shipping the heads back.
Personally I'd probably just spend the $250 or so to have mine worked over. But machine shop prices vary quite a bit so some might find this a very good deal.
Personally I'd probably just spend the $250 or so to have mine worked over. But machine shop prices vary quite a bit so some might find this a very good deal.
#10
Best way to catch Will is to call him during business hours, you may have to leave a message. His new number at his new location in Lexington, VA is 540-462-7353. I believe he plans to be are URE as well, but not 100% on that Harold.
Thread
Thread Starter
Forum
Replies
Last Post
JBEGIN
Discovery II
21
06-27-2009 12:38 PM
Tony1788
Retired - Private For Sale/Trade Classifieds
0
05-07-2008 12:29 PM