Engine is bad, front bumper is sold, right headlight cracked. Everything else is available. Let me know what you need.

 

I'm interested in the jump seat conversion. PM sent

 

do you think the 4.6 rotating assembly is still good? or did they get wiped out too?

 

If you're looking for the crank, it may be a week or so before I get to actually tear down the engine but I do plan on it. I'll mark is as your for the time being pending further examination.

I just ran codes this morning and all I got were P1481 which is the leak detection pump in the EVAP system, P1319 which is low fuel level misfire, P0301, P0308 and P0150 which is a bad sensor Bank 2 Sensor 1. The engine may in fact be in better shape than the seller thought. I'll be investigating further over the next several days.

 

I have a nice full set of rubber mats, black cup holders, Hurricanes, clean rear bumper ect.

 

You have the rubber mats that sit on the dash and in the doors?

 

Yes, I have them. I sent you a PM with details.

 

I would be interested in the floor mats, as well as the air intake plenum if they are still available.

 

The mats are still available. Do you want fronts, rears and cargo area?

As far as the plenum goes, I assume you're asking about the cowl that goes underneath the windshield and conceals the wiper assembly. I have it, it appears to be fine but I have selling a part like that until I have it off the truck and it may be awhile. To safely remove the cowl I like to have the fenders and the hood off as well.

Let me know about the mats. I expect they won't last that long. As far as the cowl is concerned, I can make note that you want it and confirm the deal once it's off the truck. I usually get $160 for the cowl and that includes the cost of shipping. It ships in about 200 feet of bubble wrap to insure it arrives in one piece

 

PM Sent