Anybody fabricate their own front bumper?
#11
As far as the actual construction, I just used an angle grinder and my mig welder. You don't even need a hole saw to join the pipes if you make the cuts right.
#13
I just used some 1.5 or 1.75" hot rolled steel for the ends and when I built the actual one I was going to use 1/4” plate for the center section. on the ends I just did pie cuts and re welded for the radius, but I was going to have some pieces mandrel bent for v.2
As far as the actual construction, I just used an angle grinder and my mig welder. You don't even need a hole saw to join the pipes if you make the cuts right.
As far as the actual construction, I just used an angle grinder and my mig welder. You don't even need a hole saw to join the pipes if you make the cuts right.
#14
#15
Thread
Thread Starter
Forum
Replies
Last Post
marsyas
Discovery II
30
02-25-2021 08:11 AM