Andrea got the table wired up and ran a couple of sample cuts they uploaded at the factory. Now to finish the set up, get it positioned and fill it up with 300 gallons of water and chemicals.

Straight off the table and didn't clean these up. Still need a bit more dial in on the thinner material.

I should be up and running again by the end of next week. I have a RR sport coming in for a few custom things next week as well. This will be an R&D build so it'll take a bit. Sliders, hidden winch mount and through bumper cover rear swing arm.

J

 

The swing arm sounds interesting love to see how that works out

 

New banner/curtain (6' x 16') was designed and approved for the shop today.

J

 

Very nice!

 

A little further on the shop. 3-4 more days and I can start burning wire again. Have to cut all the lower shelves for the tables so I can unload the last 2 pallets of misc tools and other supplies.



Press brake arrives Mon/Tues per freight tracking and a steel stocking order will arrive next week as well.



One of the guys from NCLR dropped off his RR Sport this morning. It'll be receiving a hidden winch, front and rear skids, sliders and a through cover rear swing arm w/ tire carrier and ladder.

J

 

Brake arrived and its wired up. Now I can position the plasma table, level and fill it up.

Also the new TT winch fairleads were delivered.

Name is on the door and I'll be ready to work again on Monday.

J

 

Table is filled up and leveled. Ready to go now.

J

 

looking good J

 

2008 Sport getting going.

Hidden winch mount w/ 11,500# Superwinch, front to transfer case skid plate, sliders w/ air tank skid, rear skid and rear swing arm through the stock shell.

J

 

Be nice with the EAS valve block. They have easily hurt feelings that makes bad things happen