Land Rover Forums - Land Rover Enthusiast Forum
Share Your Pictures with Our Community. Upload Now
Replacement (used) starter ready to install.
Replacement (used) starter ready to install.
0 2010/04/11 18:57:03
Driver's floorboard after carpet removal.
Driver's floorboard after carpet removal.
0 2010/04/11 18:51:15
CDL as greased up and ready to dance!
CDL as greased up and ready to dance!
0 2010/04/11 18:51:15
Drivers floorboard at door sill. What is that black piece? Is that a factory patch job? Same thing in same place on passengers floor.
Drivers floorboard at door sill. What is that black piece? Is that a factory patch job? Same thing in same place on passengers floor.
0 2010/04/11 18:51:15
Top of fuel pump when cover was removed
Top of fuel pump when cover was removed
0 2010/04/11 18:45:43
Optional Access Panel Passenger's floorboard.
Optional Access Panel Passenger's floorboard.
0 2010/04/11 18:45:43
Close-up view thru the optional access panel.CDL Shifter Pivot point on right, Neutral switch on the left.
Close-up view thru the optional access panel.CDL Shifter Pivot point on right, Neutral switch on the left.
0 2010/04/11 18:45:43
Almost got her Vertical!
Almost got her Vertical!
0 2010/04/09 23:19:07
Without the lift. Still looks good!
Without the lift. Still looks good!
0 2010/04/09 23:19:07
My best picture of her.
My best picture of her.
0 2010/04/09 23:19:07
The little guys all snuggeled up and ready for bed. The Rover and ML fit behind them w/ the door closed.
The little guys all snuggeled up and ready for bed. The Rover and ML fit behind them w/ the door closed.
1 2010/04/07 08:19:52
The cametra was installed a little differntly than the apckage described. Instead of screwing it to the license plate I took the third brake light apart and enlarged the hole in the back where the stock light snaps in. I then drilled a 1.25 hole in the red plastic to allow the camera to see out. I installed two new smaller snap in lights to allow the brake light to still function. I fished the wire down and out the factory grommet into the interior. I tapped into the reverse lights (black / ground solid green ) for camera power. When 12V is applied to the camera the front screen recognizes video and turns on. Up high is great as I can see over the boat to back up. Hopefully my wife will also see behind her.
The cametra was installed a little differntly than the apckage described. Instead of screwing it to the license plate I took the third brake light apart and enlarged the hole in the back where the stock light snaps in. I then drilled a 1.25 hole in the red plastic to allow the camera to see out. I installed two new smaller snap in lights to allow the brake light to still function. I fished the wire down and out the factory grommet into the interior. I tapped into the reverse lights (black / ground solid green ) for camera power. When 12V is applied to the camera the front screen recognizes video and turns on. Up high is great as I can see over the boat to back up. Hopefully my wife will also see behind her.
0 2010/04/07 08:10:18
Advertisement
Another stray. My first Rover. I am officially hooked.
Another stray. My first Rover. I am officially hooked.
0 2010/04/07 08:10:18
I went w/ charcoal on the headliner. I personally like the contrast. Total cost was around $400 to include a gallon of fiberglass, fiberglass matt, 3 yards of 64" Wide headliner material and the glue.
I went w/ charcoal on the headliner. I personally like the contrast. Total cost was around $400 to include a gallon of fiberglass, fiberglass matt, 3 yards of 64" Wide headliner material and the glue.
1 2010/04/07 08:07:04
Black headlinefr
Black headlinefr
0 2010/04/07 08:07:04
After mrs speakerdude backed the Rover into the Benz I decided to add a rear camera. It works great ($129 from Autozone)
After mrs speakerdude backed the Rover into the Benz I decided to add a rear camera. It works great ($129 from Autozone)
0 2010/04/07 08:07:04
Steering wheel repaird after dying the old brown part balck
Steering wheel repaird after dying the old brown part balck
0 2010/04/07 08:03:41
Headliner out for repair. While out I soundproofed the roof and inside all doors. I installed new Focal door speakers front and rear and reinforced the woofer cover in the rear door.
Headliner out for repair. While out I soundproofed the roof and inside all doors. I installed new Focal door speakers front and rear and reinforced the woofer cover in the rear door.
0 2010/04/07 08:03:41
I fiberglassed the back to reinforce everything prior to installing the new liner
I fiberglassed the back to reinforce everything prior to installing the new liner
0 2010/04/07 08:03:41
91 C4 964 Targa. Stock except for H&R lowering springs and new wheels and tires
91 C4 964 Targa. Stock except for H&R lowering springs and new wheels and tires
0 2010/04/07 08:01:07
I bought the C4 to drive all year. Forget about it, it will go nowhere quick in the snow.
I bought the C4 to drive all year. Forget about it, it will go nowhere quick in the snow.
0 2010/04/07 08:01:07
Two new buddies that are hanging around the house
Two new buddies that are hanging around the house
0 2010/04/07 08:01:07
The wife's driver. That is not my wife, my wife is taller. It is pretty much a dead stock 98 M3 automatic
The wife's driver. That is not my wife, my wife is taller. It is pretty much a dead stock 98 M3 automatic
0 2010/04/07 07:58:26
The one that got away. I sold it to buy the 964 / big mistake. This was the best car I ever owned.
The one that got away. I sold it to buy the 964 / big mistake. This was the best car I ever owned.
0 2010/04/07 07:58:26
964 rear deck lid
964 rear deck lid
0 2010/04/07 07:58:26
My solution to LR charging $700 for the damaged plastic bumper cover. Split it in half. Plan is to use the driver's fog lamp opening to feed a pressurized airbox.
My solution to LR charging $700 for the damaged plastic bumper cover. Split it in half. Plan is to use the driver's fog lamp opening to feed a pressurized airbox.
0 2010/04/07 07:51:53
Profile shot.
Profile shot.
0 2010/04/07 07:51:53
This is the harness I made for the lighting. It connects directly to B and uses Bosch relays triggered by the old headlight wiring. This allow the much higher current for all the lights to not try to pass through the fuse box. Each set of lights is individually fused. I made a few of these for members on a Porsche forum that I frequent, they work great.
This is the harness I made for the lighting. It connects directly to B and uses Bosch relays triggered by the old headlight wiring. This allow the much higher current for all the lights to not try to pass through the fuse box. Each set of lights is individually fused. I made a few of these for members on a Porsche forum that I frequent, they work great.
0 2010/04/07 07:46:33
Killer stereo for a little car. Polk 2 way plates customk fitted into the stock 4X6 front holes using stock grills, Polk 6X8 mazda / Ford coaxes mounted in the stock rear hole, (2) Polk 6X9 wooifers mounted in custom .75 cu/ft drop in enclosures in the rear wheelwells. SONY 250W mono amp under passenger seat for the woofers, additional 4X50 W SONY amp by spare tire. New rear hatch carpet allows the woofers to not be seen.
Killer stereo for a little car. Polk 2 way plates customk fitted into the stock 4X6 front holes using stock grills, Polk 6X8 mazda / Ford coaxes mounted in the stock rear hole, (2) Polk 6X9 wooifers mounted in custom .75 cu/ft drop in enclosures in the rear wheelwells. SONY 250W mono amp under passenger seat for the woofers, additional 4X50 W SONY amp by spare tire. New rear hatch carpet allows the woofers to not be seen.
0 2010/04/07 07:46:33
In-dash Blaupunkt AM-FM-CD to look period correct. Schnell rear short shift kit and Speedforce Racing front short shift kit. The throw is approximately 3 inches and extremely quick.
In-dash Blaupunkt AM-FM-CD to look period correct. Schnell rear short shift kit and Speedforce Racing front short shift kit. The throw is approximately 3 inches and extremely quick.
0 2010/04/07 07:46:33
I made a custom wiring harness for the lights to allow running H4 Hellas 100 / 55 in the stock headlights, 100 W driving lights in the upper bumper, 100 W driving lights in the lower grill. In addition I have a relay set up from inside that will defeat the running lights and brake lights and only leave the headlights on. It is virtually impossible to follow if for some reason you are speeding on a back road and need to move on.
I made a custom wiring harness for the lights to allow running H4 Hellas 100 / 55 in the stock headlights, 100 W driving lights in the upper bumper, 100 W driving lights in the lower grill. In addition I have a relay set up from inside that will defeat the running lights and brake lights and only leave the headlights on. It is virtually impossible to follow if for some reason you are speeding on a back road and need to move on.
0 2010/04/07 07:42:24
17" Mille Miglia carrera Cup wheel copies that have the proper offset for the early 944 w/o spacers. 225X55X17 front and 245X40X17 rear sticky Yokohamas
17" Mille Miglia carrera Cup wheel copies that have the proper offset for the early 944 w/o spacers. 225X55X17 front and 245X40X17 rear sticky Yokohamas
0 2010/04/07 07:39:18
Advertisement