Land Rover Forums - Land Rover Enthusiast Forum
0 2017/05/28 17:48:00
0 2017/05/28 17:47:48
0 2017/05/28 17:47:42
0 2017/05/28 17:47:32
Image #4
Image #4
0 2017/05/28 17:45:28
Image #5. It took about 8 hours to get to this point. Happy, but anxious about lining up the new motor mounts and putting it all back together, tomorrow.
Image #5. It took about 8 hours to get to this point. Happy, but anxious about lining up the new motor mounts and putting it all back together, tomorrow.
0 2017/05/28 17:40:10
Image #4 Long nosed die grinder from HFT. 1/4" collet. They had very few offerings for bits or cutting wheels or stones or anything with a 1/4" spindle.
Image #4 Long nosed die grinder from HFT. 1/4" collet. They had very few offerings for bits or cutting wheels or stones or anything with a 1/4" spindle.
0 2017/05/28 17:37:30
Image 3.1 Top side of the top plate from the passenger side after the base of the bolt was ground off from the underside on the bench grinder. Note the square base.
Image 3.1 Top side of the top plate from the passenger side after the base of the bolt was ground off from the underside on the bench grinder. Note the square base.
0 2017/05/28 17:35:54
Image #3. Bottom side of the top plate of the passenger side motor mount after a few minutes on the bench grinder. Note the similar, but smaller, metal disc that holds in the anti-twist pin. A bigger version of that was backing the threaded bolt.
Image #3. Bottom side of the top plate of the passenger side motor mount after a few minutes on the bench grinder. Note the similar, but smaller, metal disc that holds in the anti-twist pin. A bigger version of that was backing the threaded bolt.
0 2017/05/28 17:33:40
Image #2. Don't let the good picture fool you. This is inside a blind rabbit-hole just big enough to squeeze a cell phone into, not comfortable for a big human hand.
Image #2. Don't let the good picture fool you. This is inside a blind rabbit-hole just big enough to squeeze a cell phone into, not comfortable for a big human hand.
0 2017/05/28 17:31:24
Image #1. Two broken motor mounts.
Image #1. Two broken motor mounts.
0 2017/05/28 17:29:40
Sure feels like a boot, but everything I'm reading says its a seal. Whatever it is, its shot.
Sure feels like a boot, but everything I'm reading says its a seal. Whatever it is, its shot.
0 2017/05/25 19:19:32
I pulled the damaged rubber piece from here.
I pulled the damaged rubber piece from here.
0 2017/05/25 19:19:26
0 2017/05/11 05:41:44
0 2017/05/11 05:39:42
Tie rod and drag link boots destroyed. No lube. Locked up when recovering from a left hand turn. Some on the other side.
Tie rod and drag link boots destroyed. No lube. Locked up when recovering from a left hand turn. Some on the other side.
0 2017/05/11 05:12:29
0 2017/05/11 05:08:29