Land Rover Forums - Land Rover Enthusiast Forum
Dark, narrow chamber of death.
Dark, narrow chamber of death.
0 2022/03/10 08:18:25
Beautiful wide views...(window needs washed)
Beautiful wide views...(window needs washed)
0 2022/03/10 08:18:13
Horror!! Grommet on order, "After" pics soon.
Horror!! Grommet on order, "After" pics soon.
0 2022/03/10 08:14:40
Pull off the rubber door seal and angle here for best results. Then cross your fingers.
Pull off the rubber door seal and angle here for best results. Then cross your fingers.
0 2022/03/10 08:12:57
You could also 3M tape it here if you go JLR's way.
You could also 3M tape it here if you go JLR's way.
0 2022/03/10 08:10:29
Tucks right under the ladder bracket and used some stainless hardware.
Tucks right under the ladder bracket and used some stainless hardware.
0 2022/03/10 08:09:28
0 2022/03/10 08:04:18
0 2022/03/10 07:34:34
0 2022/03/02 07:40:58
0 2022/02/28 11:42:21
0 2022/02/27 12:37:06
0 2022/02/27 12:36:51
0 2022/02/27 12:36:41
From the "inside", check your gap. Don't crank down the lug nuts until you check. If it kisses, grind more. If it doesn't kiss, tighten lug nuts more. When fully torqued and I had >1/16", I was done.
From the "inside", check your gap. Don't crank down the lug nuts until you check. If it kisses, grind more. If it doesn't kiss, tighten lug nuts more. When fully torqued and I had >1/16", I was done.
0 2022/02/27 12:32:06
Also did a 1" lift. Interestingly, it doesn't take a lot of adjustment to get an additional 1". Didn't realize that it wasn't a 1:1 ratio.
Also did a 1" lift. Interestingly, it doesn't take a lot of adjustment to get an additional 1". Didn't realize that it wasn't a 1:1 ratio.
0 2022/02/27 12:31:58
Grind away until you want to cry! Wear goggles, mask, and ear protection.
Grind away until you want to cry! Wear goggles, mask, and ear protection.
0 2022/02/27 12:31:48
First side started with 1/16" marks on top & bottom fins. Second side started at 3/16" which was much better aiming point.
First side started with 1/16" marks on top & bottom fins. Second side started at 3/16" which was much better aiming point.
0 2022/02/27 12:31:38
Use a T-35 Torx bit.
Use a T-35 Torx bit.
0 2022/02/27 12:27:21
Damper on the left comes off very quickly. Also was shocked how rough the rotors were after 5,300 miles. Starting to get crazy gouges after a short haul.
Damper on the left comes off very quickly. Also was shocked how rough the rotors were after 5,300 miles. Starting to get crazy gouges after a short haul.
0 2022/02/27 12:27:06
Depending on floor jack, you may not have to do this. I have a height thing that made it more challenging.
Depending on floor jack, you may not have to do this. I have a height thing that made it more challenging.
0 2022/02/27 12:26:51
Definitely need a new setup for this crazy mount point.
Definitely need a new setup for this crazy mount point.
0 2022/02/27 12:26:34
Hockey puck on floor jack worked but was sketchy.
Hockey puck on floor jack worked but was sketchy.
0 2022/02/27 12:26:18
The ground slopes to the right making the Wrangler look much higher. In real life it's < than 1/2".
The ground slopes to the right making the Wrangler look much higher. In real life it's < than 1/2".
0 2022/02/27 12:21:29
That tire is a "Beast" to put up there.
That tire is a "Beast" to put up there.
0 2022/02/27 12:21:09
Much more tire on the new Nitto's on the right.
Much more tire on the new Nitto's on the right.
0 2022/02/27 12:20:51
0 2022/02/16 16:35:26
0 2022/02/15 04:56:29
0 2022/02/10 06:58:04
0 2022/02/08 11:24:54
0 2022/02/07 05:41:10
0 2022/02/07 05:41:06
0 2022/02/07 05:41:02
0 2022/02/07 05:40:59
0 2022/01/26 10:27:06
0 2022/01/24 10:32:32
0 2022/01/15 17:25:45
0 2021/11/22 14:27:03
0 2021/09/23 10:37:22
0 2021/09/16 15:01:45
0 2021/09/16 15:01:41