Looking to build a rear bumper for my Disco 2 just because the plastic one I have is already cracked.
Open to suggestions for material but currently thinking of building with 50mm by 100mm RHS.
Wondering if anyone has measurements for the rear of the disco and how wide the inside of a bumper should be, as well as any other helpful tips.

 

not to ruin your ideas, but for a few hundred bucks, you can buy a pre-made steel bumper for your Disco.

 

Building is more funner if ya gots the skilz!!

 

I plan to build one as well, please post pictures Ill let you know when I get that far on mine.

 

I built my own with scrap steel from shipping skids. Maybe not the prettiest but works great. Rear winch is perfect for pulling cars, at a and lawnmowers onto my trailer.

 

Few questions for you on this. is the front piece square tubbing? and either way you got pics from the backside of ?

Looks great too

 

It’s not square tube, it was a c channel with 1/2” returns, I’ll look for some other pics, the bumper is holding up ok but needs some paint. I am going to change it up a bit, I drug it off a rock ledge while off-roading and peeled it up a bit, I’m going to cut the rear body and extend the sides to the rear wheel well and tie it back to the frame.

 

These are pics I found during mock up