Landy cut out
#21
The following users liked this post:
Kobus van Eeden (06-14-2015)
#22
#23
The pick-up coil amplifier or ignition coil are what I suspect is overheating. The amplifier is outside where you can see it and is screwed to the body of the distributor, bigger than a book of matches. The ignition coil is mounted to the radiator support, follow the middle distributor cap wire back to it, old ones where filled with oil as insulator. Both commonly just quit but the amplifier gets so hot where it's mounted it will present the type of problem your having. Guys have moved the amplifier to an inner fender location so that it gets cooling away from the hot engine.
Last edited by ihscouts; 06-14-2015 at 10:08 AM.
The following users liked this post:
TOM R (06-14-2015)
#24
Hi ihscouts, 7 month ago I replaced the pick up coil amplifier, not that there was any problems with the old one, I struggle with this problem for a couple of years now so I am out of idea's I have change a lot of things over this time, obvious not what cause this problem. What I pick up is that when I disconnect the white and purple wire on the petrol pump and connect a wire from the ignition to the place were the white and purple wire goes the landy doesn't cut out.
#27
its 14cux. EPA doesnt apply outside of A. not everything they made after 96 was obd2
if theres no spark then there is probably no fuel. the secondary coil wire triggers the ecm to fire the injector and reset the 2 second timeout for the fuel pump
The following users liked this post:
TOM R (06-15-2015)