Hey all,

trying to pull apart a rocker arm setup apart to install new, steel rockers. The first, old rocker arm came right off, but then I got to the first pedestal… and it’s not budging… is there a shim or something that I’m missing here? Should i just pry-away?

Thanks!

 

the shaft is likely deformed a little where the pedestals/bolts were......just be careful and try to tap it off, might help to twist as you tap, you could also try heating the pedestal a little

 

yes, can confirm, just needed some hammering. Thanks.

 

Maybe some penetrating oil or gasoline will help break the varnish. It will just slide on after you clean it up and put it back together.