Stock running boards - rubber moulding issue
Thread Starter
|
Winching
Joined: Aug 2009
Posts: 561
Likes: 28
From: Vancouver, B.C.
Stock running boards - rubber moulding issue
Hi,
I am helping my brother tidy up little annoyances on his '99 Discovery 1.
The stock side running boards have rubber that goes around the edges, but it is currently falling off in some areas.
Is there a trick to re-applying the rubber? It appears to be grooved, but a major PITA to slip back on. Also, should there be an adhesive?
See pic for visualization.
Thanks
see the rubber is separating from the metal. Without the rubber, that side step/running board is jagged.
I am helping my brother tidy up little annoyances on his '99 Discovery 1.
The stock side running boards have rubber that goes around the edges, but it is currently falling off in some areas.
Is there a trick to re-applying the rubber? It appears to be grooved, but a major PITA to slip back on. Also, should there be an adhesive?
See pic for visualization.
Thanks
see the rubber is separating from the metal. Without the rubber, that side step/running board is jagged.
Last edited by archaeology_student; Jul 23, 2018 at 11:18 AM.
Thread
Thread Starter
Forum
Replies
Last Post
carid
Appearance & Camping Set Ups
0
Jan 9, 2015 04:22 AM
d2rover
Retired - Private For Sale/Trade Classifieds
2
Jun 21, 2012 06:28 PM
