I've read through most of past threads. I can't imagine how I would rewire a new harness connector on my back...in the middle of the desert. My gut is sinking just wondering how I could of done this. Possibly with a screw driver pushing one tab in? ugh. I'm sick. I had crossed my fingers hoping this wasn't a bad sign but once I finished installing the new 02 sensor. Turned the truck over, the check engine light come on and with two extra codes. Now I have three codes not one pop up. No activity, heat circuit, and Bank 2 sensor 1? Unconnected the harness, looked for melted wires and found nothing and reconnected. Rev'd the engine up to 2500 RPM's for a few minutes. Same codes pop up.

 

That's something I've never seen.

I don't have a good answer but there's a ton of info in this thread incl connector pics/pinouts etc https://landroverforums.com/forum/di...r-82684/page2/

 

What am I looking at? Is that a burn mark, the dark spots? I have one with broken tabs and successfully zip-tie it in place.