Discovery II Talk about the Land Rover Discovery II within.
Sponsored by:
Sponsored by:

rear door adjustment? Sagging? Dragging?

Thread Tools
 
Search this Thread
 
  #11  
Old 07-04-2016, 01:55 PM
jhmover's Avatar
Three Wheeling
Join Date: Mar 2014
Location: San Francisco Bay Area
Posts: 90
Likes: 0
Received 7 Likes on 6 Posts
Default

My old D2 did that, needed new hinges.

Cause, 1st rain of the year some moron in a Bronco rear ended me due to his almost bald tires. Upon inspection I could see nothing obvious and it was a very slight tap. I later noticed water and spent several hours trying to adjust the hinges to no avail.

I took it to a friend who had a body shop at the time and he confirmed the hinges were slightly bent. So I had him replace them and never had anymore problems while I had it.
 
  #12  
Old 07-08-2016, 01:19 PM
NVDiscovery's Avatar
Rock Crawling
Join Date: Feb 2015
Location: Upstate South Carolina
Posts: 337
Received 63 Likes on 51 Posts
Default

It should only take about 60-90 minutes to replace the rear door hinges. I replaced mine and it closes fine. I think that the previous owner's kids played on the ladder with the door open and bent the hinges. Good luck!
 
  #13  
Old 07-13-2016, 08:28 PM
philnewell's Avatar
Drifting
Join Date: Sep 2006
Location: Scottsdale, AZ
Posts: 25
Likes: 0
Received 3 Likes on 2 Posts
Default

I just went through this issue, rear door was sticking for months and finally (while camping of course) the rear door jammed and would not open. Here is what I did:
1. Ordered replacement hinges from RoverParts.
2. Remove Spare Wheel
3. Get in car and gently! kick the rear door open.
4. Remove rear door trim
4a. Jack up rear door until bumper raises a couple of inches
5. Loosen top and bottom hinges until the door moved up.
6. Nip up bolts, lower jack and check door alignment as it is about to close.
7. Repeat until you get the door to be a couple of millimeters too high.
8. Torque up the door bolts.
9. Put spare back on door.
10. Validate that the door is closing and opening correctly (Repeat if not)
11. Return new hinges to Roverparts :-)
PS: May need to replace door seal, not sure yet, but I live in AZ so it is more of a dust issue than a rain issue.
Obviously my hinges were not damaged.
Hope this helps...
 

Last edited by philnewell; 07-13-2016 at 08:30 PM. Reason: Forgot a step
The following 2 users liked this post by philnewell:
garrddogg (07-20-2016), JUKE179r (04-15-2019)
  #14  
Old 07-20-2016, 07:19 PM
garrddogg's Avatar
Three Wheeling
Join Date: Jun 2015
Posts: 80
Received 5 Likes on 3 Posts
Default

Im going to have to check mine, I get a little bit of rain but the dust is my issue as well. dusty AZ.

Originally Posted by philnewell
I just went through this issue, rear door was sticking for months and finally (while camping of course) the rear door jammed and would not open. Here is what I did:
1. Ordered replacement hinges from RoverParts.
2. Remove Spare Wheel
3. Get in car and gently! kick the rear door open.
4. Remove rear door trim
4a. Jack up rear door until bumper raises a couple of inches
5. Loosen top and bottom hinges until the door moved up.
6. Nip up bolts, lower jack and check door alignment as it is about to close.
7. Repeat until you get the door to be a couple of millimeters too high.
8. Torque up the door bolts.
9. Put spare back on door.
10. Validate that the door is closing and opening correctly (Repeat if not)
11. Return new hinges to Roverparts :-)
PS: May need to replace door seal, not sure yet, but I live in AZ so it is more of a dust issue than a rain issue.
Obviously my hinges were not damaged.
Hope this helps...
 
  #15  
Old 04-03-2022, 10:27 AM
Harvlr's Avatar
TReK
Join Date: Sep 2020
Location: British Columbia Canada
Posts: 2,191
Received 525 Likes on 455 Posts
Default

I adjusted mine similarly to Philnewel’s explanation above, but didn’t take anything apart. I loosened the bolts attaching the hinge fittings to the car, then I lifted up on the (now) rear corner of the door and had my wife snug the bolts up. The first try I went too high so we repeated not quite as high and it works well.
 
The following users liked this post:
SadaJones (04-12-2022)
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
mrobey
General Tech Help
5
01-25-2012 12:37 PM
NZDiscovery
Discovery I
2
09-25-2010 09:23 PM
Disco23
General Tech Help
0
05-11-2008 07:49 PM
brooksa
Discovery II
1
12-28-2007 09:08 AM
mcneal
Discovery II
1
10-25-2007 02:21 PM



Quick Reply: rear door adjustment? Sagging? Dragging?



All times are GMT -5. The time now is 08:55 AM.