Discovery II Talk about the Land Rover Discovery II within.
Sponsored by:
Sponsored by:

Replaced Crank Sensor, Runs Rough

Thread Tools
 
Search this Thread
 
  #11  
Old 01-14-2015 | 03:59 PM
BigKyle99's Avatar
Thread Starter
|
6th Gear
Joined: Sep 2013
Posts: 6
Likes: 0
Default

So, I re-installed the Crank sensor and cover, made sure that the harness had a good connection and I am still getting the same crappy running motor. Check engine light is not flashing at idle though, not sure if that is good or bad... Checked fuse #2, it is still good, exchanged it with a new fuse and still cant get a reading from the scanner... I am not sure when these other electrical problems occurred but, the radio, compass in the mirror and windshield wipers (front and back) are no longer working... Would they all be on the same circuit as the scanner?
 
  #12  
Old 01-14-2015 | 08:00 PM
BigKyle99's Avatar
Thread Starter
|
6th Gear
Joined: Sep 2013
Posts: 6
Likes: 0
Default

Also, I just found that the wires on the back of the passenger side knock sensor had been completely pulled out from the connector. As I understand it, the knock sensor could cause the issues that I am having with lack of power and it sounding like the timing is out of whack... Where can i find a new connector that will plug into the knock sensor? is my best bet going to a junk yard to find it? Thanks
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
CoMo
Discovery II
9
06-25-2014 03:34 PM
roverguy67
Discovery II
14
09-30-2012 11:39 AM
PK Disco 2
Discovery II
10
04-10-2011 02:28 AM
boldingm
General Tech Help
0
04-24-2010 06:06 PM
mordor110
Discovery II
5
03-20-2007 02:21 PM



Quick Reply: Replaced Crank Sensor, Runs Rough



All times are GMT -5. The time now is 09:37 AM.