Discovery II Talk about the Land Rover Discovery II within.
Sponsored by:
Sponsored by:

Replacing rear carpet with plywood?

Thread Tools
 
Search this Thread
 
  #1  
Old 08-18-2021 | 12:45 PM
TyTyBinks's Avatar
Thread Starter
|
Three Wheeling
Joined: Jun 2020
Posts: 93
Likes: 5
From: Richmond, Virginia
Default Replacing rear carpet with plywood?

My carpet in the back of my disco has started to smell so I removed it and found some surface rust and the carpet was soaked. I was thinking about replacing the carpet with a sheet of plywood covered in marine carpet to prevent it from happening again.

has anyone else done this in the past? If so how did it work. And what other recommendations do y’all have for replacing the carpet? I was thinking about just spraying it with bedliner but then I read about how much noise it makes.

thanks!
 
  #2  
Old 08-18-2021 | 01:18 PM
tnrangerover's Avatar
Rock Crawling
Joined: Oct 2020
Posts: 319
Likes: 151
From: Nashville, TN
Default

go for it. just make sure to bolt it down. you could also rip the foam out, recover the floor with dynaliner and sound deadener, and then put the carpet back in once it has dried out. the stock foam is open cell, so it holds water.
 

Last edited by tnrangerover; 08-18-2021 at 01:21 PM.
  #3  
Old 08-18-2021 | 01:23 PM
TyTyBinks's Avatar
Thread Starter
|
Three Wheeling
Joined: Jun 2020
Posts: 93
Likes: 5
From: Richmond, Virginia
Default

Yeah I have a seven seater with both of the jump seats out so I was planning on bolting it down with the mounting points for the seats. I was looking at dyna liner but it is way too expensive for me. I was thinking about putting spray foam into all of the divots and trimming it flush to make the bed flat. I think that could help with sound and make the plywood more sturdy.
 

Last edited by TyTyBinks; 08-18-2021 at 01:46 PM.
  #4  
Old 08-18-2021 | 02:15 PM
mollusc's Avatar
TReK
Joined: Nov 2015
Posts: 3,447
Likes: 799
From: Staten Island, NY
Default

Make sure you address whatever is causing the water to get in too -- possibly sunroof.
 
  #5  
Old 08-18-2021 | 02:17 PM
TyTyBinks's Avatar
Thread Starter
|
Three Wheeling
Joined: Jun 2020
Posts: 93
Likes: 5
From: Richmond, Virginia
Default

Yeah my dad and I have been chasing the leak for the past couple of years. I’m trying to slowly work my way through the car to figure it out
 
  #6  
Old 08-18-2021 | 04:22 PM
TyTyBinks's Avatar
Thread Starter
|
Three Wheeling
Joined: Jun 2020
Posts: 93
Likes: 5
From: Richmond, Virginia
Default

I think my final plan is to:
  1. Treat the rust spots
  2. spray it with rust preventative primer
  3. Spray with bedliner
  4. fill all the gaps with spray foam
  5. make a plywood floor
  6. Paint plywood with mold mildew repellent
  7. cover plywood with marine carpet

any thoughts on this?
 
  #7  
Old 08-18-2021 | 06:09 PM
Saturnine's Avatar
Pro Wrench
Joined: Jan 2018
Posts: 1,719
Likes: 257
From: Denver
Default

Make sure you can still gain access to the fuel pump
 
  #8  
Old 08-18-2021 | 06:10 PM
TyTyBinks's Avatar
Thread Starter
|
Three Wheeling
Joined: Jun 2020
Posts: 93
Likes: 5
From: Richmond, Virginia
Default

I was planning on making a batch for it
 
  #9  
Old 08-18-2021 | 06:37 PM
Dave03S's Avatar
TReK
Joined: Nov 2011
Posts: 2,748
Likes: 505
From: Seattle, Wa
Default

The most common leak that makes the rear carpet wet is the weather seal at the top of the tailgate.

I used backing cord tucked into the fold it has to bolster it.

yiu may also need to adjust your gate latch or hinges to close that gap.
 
  #10  
Old 08-20-2021 | 01:13 PM
TimInNova's Avatar
Rock Crawling
Joined: May 2019
Posts: 375
Likes: 187
From: Northern Virginia
Default

Something like this would be sweet:



Heck, this would be even better ;-)


 


Quick Reply: Replacing rear carpet with plywood?



All times are GMT -5. The time now is 10:26 PM.