Throttle body froze up
#31
#32
My TB froze stuck open this AM.. Made it all the way to work fine but last mile MagPie felt funny
Parked and threw the shifter into park and the revs shot up to 2800 and then I turned it off.
Popped the hood and manually opened and closed both TB linkages, seemed alright.
I do have the lines running to the TB and it was probably -10 this morning.
Parked and threw the shifter into park and the revs shot up to 2800 and then I turned it off.
Popped the hood and manually opened and closed both TB linkages, seemed alright.
I do have the lines running to the TB and it was probably -10 this morning.
#37
#40
If you get the TB off, get squares of 180 and 220 Grit Sandpaper. you'll see the contact surface for the heater plate is rounded, mine was anyway. I started with the 180 going straight forward and back, turn 90 degrees and repeat until I had a satisfactory surface area, and then did 220 to further prep it and flatten it out. I am guessing I am getting a .5mm or more of contact for the gasket/heater plate. The torques is so low on that plate that my thought process is any little bit helps. I've heard that just using The Right Stuff will seal it too, but I have never tried it.