Walnut Rear Gate Door Panel Custom Handle
#1
Walnut Rear Gate Door Panel Custom Handle
Well finally got my winter project completed. I had a roll of Walnut Veneer around my woodshop and decided it would be cool to match the walnut interior up from with a rear Walnut panel. It is held on the gate with epoxied rare earth magnets. I ditched the Christmas tree panel pins. I think it looks great and has a copper pipping recessed trim on the ends to add to the rich look. When the pictures were taken it was not flat against the door yet. I also added the Dyno mat style dampening inside the door for the sub. It sounds great. I finished it in Arm-A-Seal wipe on Oil-Urathan
#3
Well finally got my winter project completed. I had a roll of Walnut Veneer around my woodshop and decided it would be cool to match the walnut interior up from with a rear Walnut panel. It is held on the gate with epoxied rare earth magnets. I ditched the Christmas tree panel pins. I think it looks great and has a copper pipping recessed trim on the ends to add to the rich look. When the pictures were taken it was not flat against the door yet. I also added the Dyno mat style dampening inside the door for the sub. It sounds great. I finished it in Arm-A-Seal wipe on Oil-Urathan
X2 on what FightOnUSC79 posted...very nice...bosshogt
Curiously though, how much did the sheet of walnut veneer cost?
#5
#7
mwindth,
The 24x48" peice of veneer was about 39.99 at Woodworking Tools Supplies Hardware Plans Finishing - Rockler.com
The 24x48" peice of veneer was about 39.99 at Woodworking Tools Supplies Hardware Plans Finishing - Rockler.com
Thread
Thread Starter
Forum
Replies
Last Post
bcolins
Discovery II
9
09-25-2012 08:40 AM
bosshogt
Retired - Private For Sale/Trade Classifieds
2
02-28-2011 05:49 PM