Well finally got my winter project completed. I had a roll of Walnut Veneer around my woodshop and decided it would be cool to match the walnut interior up from with a rear Walnut panel. It is held on the gate with epoxied rare earth magnets. I ditched the Christmas tree panel pins. I think it looks great and has a copper pipping recessed trim on the ends to add to the rich look. When the pictures were taken it was not flat against the door yet. I also added the Dyno mat style dampening inside the door for the sub. It sounds great. I finished it in Arm-A-Seal wipe on Oil-Urathan

 

Not gonna lie! That looks fairly ****. Adds a bit of Arrogance to our already amazing Vehicles.

 

Winter project, LOL...

X2 on what FightOnUSC79 posted...very nice...bosshogt

Curiously though, how much did the sheet of walnut veneer cost?

 

Boss, now what you have to do is add some wood to the exterior making it a 4x4 off road woody wagon.

 

I think Walnut door handles are next on the customization list. They would be a bit mor complicated, but not too hard. Too bad the entire door panel much be removed in order to remove the door panel. I tried removing all the srews but they will not come loose.

 

mwindth,
The 24x48" peice of veneer was about 39.99 at Woodworking Tools Supplies Hardware Plans Finishing - Rockler.com

 

Not as bad as I expected...now, if I can recall what I learned in Coach Adams' wood shop class in 10th grade, I might have a chance, LOL

 

Very nice work! I like the "Woody Disco" idea, here's some motivation

 

Nice boss!

 

Ive been a woodworker/ contractor for 25+ years and I like it!!! Working with wood is a passion .... so is owning a Rover . Great job sir